2
Key
Arc cut-outs
aligned
3
Male = Pins extracted
Pins
extracted
Gently
PanMPO Connector Changeover Instructions
1
Squeeze
Arc cut-outs
aligned
Key
3
180°
Arc cut-out
not aligned
Arc cut-out
not aligned
Key
Female = Pins retracted
Pins
retracted
1
4
CAUTION! Only Panduit tool is to be
used for gender change. Use of any
other tool can cause fiber damage and
will void the product warranty.
Pin retraction
tool
hole
2
5
Aligned
(For PanMPO Connectors only)
See reverse side for Pulling Eye Removal Instructions (if applicable)
© Panduit Corp. 2018
INSTALLATION INSTRUCTIONS
Polarity Changeover
Squeeze both sides of outer housing at the back end evenly
until you hear an audible click.
Rotate outer housing 180° so arc cut-out is on the opposite side.
Key Up
Pull outer housing off connector.
4
Key Down
Aligned
Re-install outer housing until you hear a faint audible click.
Method A
Method B
Aligned
Aligned
AlignedNot Aligned
FS074B
Singlemode only. The polarity of singlemode connectors must not be altered. When assembling the outer housing verify that the arc cutouts and white dashes align on both sides of the PanMPO housing.
Gender Changeover
Remove outer housing per polarity changeover instructions. Locate hole in the inner housing on the slotted side and position
pin retraction tool over the hole.
Insert tool into hole, press down gently, and push forward to
advance connector pins to the male state. Repeat process in
opposite direction to retract pins for female state.
For Technical Support: www.panduit.com/resources/install_maintain.asp
Re-install outer housing in the correct orientation. See polarity
changeover instructions above.
Page 1 of 2
© Panduit Corp. 2018
6
expandable
sleeve
5
split loom
tube
4
electrical tape
heat shrink
3
slot
2
1
ripcord
INSTALLATION INSTRUCTIONS
See reverse side for PanMPO Connector Changeover Instructions (if applicable)
Pulling Eye Removal Instructions
Close the loop on the nylon ripcord. Pull the loop through the slot in the heat shrink towards the front of the assembly.
FS074B
The heat shrink should split open. Remove the heat shrink. Unwrap and remove the electrical tape
(if present).
Slide the expandable sleeve over the split loom tube containing the connectors. Carefully remove the split loom tube.
www.panduit.com/resources/install_maintain.asp
For Instructions in Local Languages
and Technical Support:
www.panduit.com
Page 2 of 2
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Loading...