Page 1
Opticom Rack Mount Fiber Enclosure
DISCARD
DISCARD
Part Number: FRME2
© Panduit Corp. 2014
INSTALLATION INSTRUCTIONS
FRME2
1 FRME Enclosure
1 FRME Kit
1 Port I.D. Label
2 Enclosure Brackets
Assembly Instructions:
Determine the cable entry location on the enclosure. Remove the knockout
by inserting a screwdriver into the slot located in the center of the knockout
and apply a twisting upward motion, then lift out. Insert grommet following
proper cutting diagram. Snap in saddle clips. Grounding lug attaches to a
stud at the rear, inside the enclosure, on the top or bottom with a #10-32
nut. Apply laser warning label and caution label in a clearly visible location.
Apply port I.D. label(s) on the inside of the door.
GROMMET CUTTING DIAGRAM
Cut the small
circle for 1"
diameter
innerduct
Cut the large
circle for 1-1/2"
diameter
innerduct
FS098
Cut the straight
lines when not
using any
innerduct
Laser Warning Label
Caution Label
Saddle Clip
For Technical Support: www.panduit.com/resources/install_maintain.asp
Grounding Lug
Grommet
Bracket
Port I.D. Label
Page 1 of 2
Page 2
© Panduit Corp. 2014
Mounting Instructions
INSTALLATION INSTRUCTIONS
Attach strain relief clip with the #10-32 screw and nut
provided.
FS098
Bracket orientation for 23 inch rack Bracket orientation for flush mount
on a 19 inch rack
Attach the short leg of the bracket to
the enclosure.
Locate rack bracket on the front
mounting holes for flush mounting
Label Installation
Bracket orientation for projection
mount on a 19 inch rack
Locate rack bracket on the mid
enclosure mounting holes for
projection mounting
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 2 of 2
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Loading...