Page 1
Opticom Fiber Optic Splice Enclosure
Part Number: FRME144SBL
© Panduit Corp. 2014
Contents:
INSTALLATION INSTRUCTIONS
5 - Pan-Ty Cable Ties (PLT2S)
10 - Tay-Ty Hook & Loop Cable
Ties (HLT2I)
8 - #12-24 x 1/2" screws
8 - #10-32 x 1/4" screws
1 - #12-24 hex nut
1 - Laser warning label
FS065
1 - Grounding lug (LAMA2-14)
1- Caution label
1 - Universal strain relief bracket
2 - Rack brackets
1 - Location label (FRME144SLB)
Cut the small
circle for 1"
diameter
innerduct
DISCARD
Slots are for
bundling cables
w i th Tak -Ty s
To remove the label,
open each clip as
shown
Cut the large
circle for 1-1/2"
diameter
innerduct
Cut the straight
lines when not
using any
innerduct
To remove the front
and rear doors,
deflect the release
tab and slide the
door off its hinge
Locate rack bracket
here for flush mounting
Locate rack bracket
here for projection
mounting
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
DISCARD
Bracket orientation
for 23 inch rack
(Attach the short leg
of the bracket to the
enclosure)
Page 2
© Panduit Corp. 2014
INSTALLATION INSTRUCTIONS
1. Insert first cable. 2. Insert Second Cable
Recommended
1 meter min. of slack
FS065
3. Remove cable jacket.
5. Insert tray (start at bottom shelf)
4. Splice cables in tray.
6. Coil Cable In Enclosure
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 2 of 2
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Loading...