Page 1
Fiber Patch Field Protection Cover - 1RU
Left and Right
Mounting Brackets
Cover
(4) #12-24 x 1/2"
D-Rings
Screws
(4) M6 x 15mm
Screws
Labels
Left mounting
bracket
Use either #12-24 x 1/2"
1
Repeat other side with right
mounting bracket. Only two
screws are used.
or M6 x 15mm screws
D-Ring
2
Insert and snap down into bracket.
Repeat right side.
Labels
3
Install labels upside-down on cover so label
reads left to right when cover is removed.
Cover
Part Number: FPFPC1
© Panduit Corp. 2014
INSTALLATION INSTRUCTIONS
FS020A
Note: FPFPC1 is not compatible with Opticom Angled Patch Panels, QuickNet Angled Patch Panels, or Angled HDQ Cassettes.
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
Page 2
© Panduit Corp. 2014
D-Ring Removal
1
2
3
Note: A flathead screwdriver may be inserted
in the bottom opening of the mounting bracket
to pry up on the D-Ring to assist in removal.
Recommended Cable Routing
INSTALLATION INSTRUCTIONS
FS020A
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 2 of 2
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Loading...