Page 1
HD Flex Universal Rear Cable Manager
Clip
Cable transitions
Populate from the base
of the clip, building
outward as needed.
2RU
Rear of Enclosure
For cables routing from
above:
Mount a minimum of
2RU above the bottom
of the lower enclosure.
Secure with (2) #12-24
or M6 screws. Panel
can feed up to 2RU of
cables.
Reverse position if
routing cables from
below.
Universal rear cable manager can be mounted two ways:
Inward towards
the enclosure
Parallel to the
enclosure
(OR)
Alternate mounting holes
Slots can be used for 3/4"
Tak-Ty Hook & Loop Cable
Ties.
Refer to step 4 for
recommended cable
routing.
(Lower enclosure shown for clarity)
Edge protectors
(top and bottom)
Apply edge protector to top
and bottom edges of panel.
Part Numbers: FLEX-CM12S, FLEX-CM18S
© Panduit Corp. 2015
FLEX-CM12S includes:
(1) Panel
(2) 12-position clips
INSTALLATION INSTRUCTIONS
(2) Edge protectors
(4) #12-24 x 1/2"
mounting screws
(4) M6 X1.0 X 15mm
mounting screws
1. Install Panel to Rack or Equipment Rail
FLEX-CM18S includes:
(1) Panel
(2) 18-position clips
FS113A
(2) Edge protectors
(4) #12-24 x 1/2"
mounting screws
(4) M6 X1.0 X 15mm
mounting screws
2. Install Cable Transitions to Clips
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
Page 2
© Panduit Corp. 2015
Push both fastener
plungers in to secure
clips to the panel.
To remove a clip, pull
fastener plungers out.
Ensure fastener
plungers are
pulled out on
both sides.
1
2
3
4
1
2
3
4
2RU
Install clips in a staggered pattern as
shown for optimum cable management.
3. Install Clips to the Panel
INSTALLATION INSTRUCTIONS
FS113A
4. Clip Configuration and Recommended Cable Routing
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 2 of 2
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Loading...