Page 1
Full Length Blanking Shade
Part Number(s) : FLBSIM-51
© Panduit Corp. 2015
INSTALLATION INSTRUCTIONS
FLBSIM-51
V00029HJ
Swapping rail pins for rails with tapped holes
• When Rails have tapped holes as opposed to the square cage nut holes, the
Rail Pins will need to be swapped out with the provided smaller diameter Rail
Pins prior to installation.
1
Rails with Tapped holes
Squeeze in tabs on
Clips to remove.
2
Replace the larger diameter pins
with the smaller diameter ones and
re-install Clips.
LISTEN TO MAKE CERTAIN THE
CLIPS ‘CLICK’ BACK IN PLACE.
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 4
Page 2
© Panduit Corp. 2015
INSTALLATION INSTRUCTIONS
Install Blanking Shade to Cabinet Rails
V00029HJ
Thumb screw
2 places
• Remove (2) thumb screws and position the Blanking Shade holes
with the Cabinet rail holes at the desired RU height.
• Secure the Blanking Shade to the Cabinet rails by re-installing the
(2) thumb screws through the rails and into the Blanking Shade.
Rail Blanking
Shade
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 2 of 4
Page 3
© Panduit Corp. 2015
INSTALLATION INSTRUCTIONS
Adjust Shade to desired position
• Push the (2) spring loaded clips of the Blanking Shade inward
and pull shade down to desired position.
• Ensure the pins of the Blanking Shade lock into the Rail holes.
V00029HJ
Shade can be drawn to a
maximum of 51 RU spaces.
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 3 of 4
Page 4
© Panduit Corp. 2015
INSTALLATION INSTRUCTIONS
Pins of Blanking Shade must lock into
Rail holes to lock Shade position.
V00029HJ
Install optional Blanking Shade Clips
1
Install Blanking Shade Clip to Rail.
2 3
Install shade to the Blanking Shade Clip.
Repeat on opposite Rail.
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 4 of 4
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Loading...