Page 1
Tak-Ty Option
Ta k -Ty
Slot features in the cable transition allows for the use of a Tak-Ty
to either secure the cable harness to a rack feature, such as
cable management fingers, or to more robustly secure multiple
cable transitions that are interlocked together.
PanMPO to LC Uniboot
3.0mm round cable clips
3.0mm round cable
Housing ribs
(Transitions interlocked)
(Cable secured in clip)
Cable management example
Cable Clips & Housing Ribs Option
LC Uniboot
PanMPO
Connectors
Connector
Cable transition
Cable Harness (Hydra)
© Panduit Corp. 2013
INSTALLATION INSTRUCTIONS
Cable Transition Usage
FS046A
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
Page 2
© Panduit Corp. 2013
1
2
3
4
4
3
Female = Pins retracted
Pins
retracted
Gently
CAUTION! Only Panduit tool is to be
used for gender change. Use of any
other tool can cause fiber damage and
will void the product warranty.
Pin retraction
tool
Hole
2
Pins
extracted
1
Outer
housing
Male = Pins extracted
INSTALLATION INSTRUCTIONS
PanMPO Gender Changeover
FS046A
Squeeze both sides of the outer housing at the back end evenly
until you hear an audible click. Pull off connector to remove.
Insert tool into hole, press down gently, and push backward to
retract connector pins to the female state. Repeat process in
opposite direction to extract pins for male state.
LC Uniboot Polarity Changeover - Pair Flipping
Locate hole in the inner housing on the slotted side and position
pin retraction tool over the hole.
Re-install the outer housing. Ensure the key is in the proper
orientation. See PanMPO polarity changeover instructions on
page 2 of FS041* for more details.
Squeeze both sides of the LC Uniboot cover evenly and
pull back to disengage the tab on the opposite side.
Rotate each LC connector downward 180°. Re-install the LC Uniboot cover until you hear an audible click.
*Denotes instruction sheet revision letter.
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
Slide the LC Uniboot cover back away from connectors and
rotate 180°.
www.panduit.com
Page 2 of 2
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Loading...