Page 1
EMA EPOXY ADHESIVE
© Panduit Corp. 2013
INSTALLATION INSTRUCTIONS
EMSK-INST
1) Bonding surface must be free of any loose particles, dirt, grease and other contaminants.
2) Remove the protective film from the mixer cup.
3) Using a stir stick, push down the center of the cup (Figure 1).
4) Scrape the two parts of the epoxy into the center of the cup and mix thoroughly (Figures
2 and 3). Note: Epoxy hardens quickly. Application time is 5 minutes at 70°F (21°C).
5) Apply 1/3 of the mixed epoxy to the bottom of a cable tie mount (Figure 4).
6) Press the mount with the epoxy firmly on the surface and twist the mount back and
forth slightly.
7) The cable tie mount is ready for use after 15 minutes at room temperature.
Figure 1 Figure 2 Figure 3 Figure 4
WARNING
Skin and eye irritant
Contains epoxy resins, amine and mercaptan hardeners
PRECAUTIONS FOR USE
1) Use in well ventilated areas.
2) Avoid contact with skin and eyes. If contact occurs, wash skin with soap and water. Flush
eyes with water. If irritation persists, see your physician.
3) Do not take internally. If accidentally swallowed, induce vomiting and call a physician.
KEEP OUT OF REACH OF CHILDREN
REFER TO SDS BEFORE USE
NOTICE TO PURCHASER
The information contained in this package is based on our experience and is believed to be reliable. No warranty,
expressed or implied, is made by Panduit Corp. with respect to adhesive bond performance. Among other things,
the conditions under which the adhesive may be applied are beyond Panduit Corp. control. We recommend that
each prospective user test his proposed application before repetitive use.
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 1 of 1 Rev 03
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Loading...