Page 1
DUCT FINGER CUTTING TOOL OPERATION INSTRUCTIONS
PA23893A01
Rev.: 01 3-2005
DFCT
© Panduit Corp. 2005
USING DFCT TO REMOVE DUCT FINGER
Part No. DFCT
OPERATION INSTRUCTIONS
DUCT FINGER
CUTTING T OOL
Cuts
P
ANDUCT
Wide Finger
Wiring Duct; and removes
NR1 Nylon Rivets
This precision tool has been engineered and
designed for use with
PANDUCT
Plastic Wiring Duct;
and to remove NR1 Nylon Rivets.
It is not intended for use on any other products or
materials.
SAFETY GLASSES MUST BE
WORN AT ALL TIMES WHEN
USING THE DFCT TOOL.
USE CARE WHEN HANDLING
TOOL; BLADE IS SHARP!
Website: www.panduit.com
Email: cs@panduit.com
For Technical Support:
888-506-5400, ext. 3255
Fax: 630-759-7532
Page: 1 of 2
DFCT TOOL
Heavy duty steel
construction
Spring open
handles
Step 1
Cut once to
remove top half
of finger
Step 2
Cut again at
level of sidewall
continued on Page 2
WARNING
CAUTION
Page 2
DFCT OPERATION INSTRUCTIONS
Step 3
Leaves a smooth
consistent edge.
Also Removes NR1 Nylon Rivets
OPTIONAL: USING DFCT & DNT-100 TO REMOVE DUCT SIDEWALL
Step 1
Use DNT-100 tool
to breakout
sidewalls at
desired location.
NOTE: DNT -100 T ool
sold separately
Step 2
Use the DFCT tool to
remove the sidewall
section at the scoreline.
Leaves a smooth
consistent edge.
Step 3
Page: 2 of 2
Loading...