Page 1
DCT
PA22193A01
REV.: 07 6-2018
DCT
© Panduit Corp. 2018
CUTTING TOOL
For Cutting Panduct
Plastic Wiring Duct
or Cover
and Heat Shrink Tubing
WARNING:
SAFETY GLASSES MUST BE
WORN AT ALL TIMES WHEN
USING THE DCT TOOL.
USE CARE WHEN HANDLING TOOL;
BLADE IS SHARP!
CAUTION:
This precision tool has been engineered and designed for use with Panduct Plastic Wiring
Duct or Cover, and Heat Shrink Tubing. It is not intended for use on any other products or
materials.
DUCT CUTTING TOOL
OPERATING INSTRUCTIONS
OPERATION
1. Determine (mark) the cut location as required.
2. Release the handle latch at the end of the handles. The handle spring allows the handles to be
normally open.
3. Position the cutting blade at the marked location and squeeze the handles together until the material is cut
through, and the blade bottoms out in the blade insert. If the cut is not long enough, also cut from the
opposite side, across from the first cut.
4. Latch the tool handles in the locked position when the tool is not being used and during transport.
REPLACEMENT PARTS
DCT-BLD Blade Replacement Kit (includes replacement blade and insert)
DCT-RI Replacement Insert (includes insert only)
Blade Replacement: Unhook spring from hook on blade. Using a wide blade standard screwdriver and 10mm
hex wrench, remove nut and screw. Slide blade upward, out of tool, and replace with new
blade. Fasten using existing screw and nut. Remember to hook spring onto hook on
blade.
Insert Replacement: Carefully pry out existing insert. Apply a small amount of Loctite Black Max (or
equivalent) to bottom of replacement insert. Place insert into lower jaw of tool
with the slotted side up.
Email:
techsupport@panduit.com
www.panduit.com
Technical Support :
1-800-777-3300
Page: 1 of 1
Loading...