Page 1
”
NET-ACCESS Power Outlet Unit Mounting Bracket
Part Numbers: CVPDUB
INSTRUCTIONS CM344C
© Panduit Corp. 2016
Power Outlet Unit (POU) Mounting Bracket Locations for Typical Tool-less Mounting Button Spacing
49.0” Button Spacing
Positioning Hole
Positioning Hole
49.0”
BUTTON SPACING
36.75” Button Spacing
36.75”
BUTTON SPACING
Positioning Hole
64.75
BUTTON SPACING
Positioning Hole
FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp
Page 1 of 4
64.75” Button Spacing
Page 2
INSTRUCTIONS CM344C
Power Outlet Unit (POU) Mounting Bracket Locations
Note location of #12-24 positioning screw in each spacing scenario. Install the positioning screw first to help locate the bracket in the correct
location and orientation relative to the cabinet frame. See page 3 for bracket and screw installation instructions.
49.0” BUTTON
SPACING
#12-24 Positioning Screw
(Bottom center slot of bracket rests
on positioning screw)
36.75” BUTTON
SPACING
#12-24 Positioning Screw
(Bracket is adjusted so that positioning screw is at bottom of bottom center slot)
64.75” BUTTON
SPACING
#12-24 Positioning Screw
(Bottom center slot of bracket rests
on positioning screw)
#12-24 Positioning Screw
(Bottom center slot of bracket rests
on positioning screw)
FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp
#12-24 Positioning Screw
(Top center slot of bracket rests on
positioning screw)
#12-24 Positioning Screw
(Bottom center slot of bracket rests
on positioning screw)
Page 2 of 4
Page 3
INSTRUCTIONS CM344C
Power Outlet Unit (POU) Mounting Bracket Installation (CVPDUB)
Use two (2) #12-24 trilobular screws to mount each CVPDUB bracket to rack. Tighten screws to 45 in-lb (+/- 5 in-lb). Refer to Pages 1 and
2 for hole and slot orientation. Install buttons of Power Outlet Unit (POU) into CVPDUB bracket as shown.
CVPDUB
(Installed)
FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp
Page 3 of 4
Power Outlet Unit (POU)
(Button of POU installed
on CVPDUB)
Page 4
INSTRUCTIONS CM344C
Power Outlet Unit (POU) Mounting Bracket Installation (non-typical button spacing)
If POU does not employ typical button spacing, mount top bracket first to locate POU. Mount lower bracket in appropriate position utilizing
bonus holes.
Bonus Holes
CVPDUB
(Installed)
For instuctions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 4 of 4
E-mail:
cs@panduit.com
Fax:
(708)444-6448
Loading...