Page 1
1.5” X 5” & 3.5” X 5”
© Panduit Corp. 2012
INSTALLATION INSTRUCTIONS
RW298
Steps Required for the Installation of the 1.5” x 5” Cool Boot Top Air Sealing Fitting
Step 1: Disengage the hook and loop cinch tie
and the hook and loop strips along the top edge
and side of the fabric sleeve. Open the fitting to
accept the existing cable bundle by separating
the end of the fitting assembly.
Step 2: Place the fitting around the cable bundle.
Step 3: Reattach the hook and loop side strip and
the cinch tie. Align Cool Boot fitting with the
cabinet top bezel and insert by pressing down on
the top of the outer edges of the fitting assembly.
Step 4: Reattach the hook and loop at the top
edge of the fabric sleeve. Pull the hook and loop
cinch tie tight around the cable bundle. Wrap
cinch tie around the cable bundle and attach it to
itself. If applicable, trim off the excess cinch tie
material.
1 2 3
4
COOL BOOT CABINET TOP AIR SEALING FITTING
Part numbers: CTGN1X5 & CTGN3X5
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
Page 2
© Panduit Corp. 2012
INSTALLATION INSTRUCTIONS
RW298
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
1
Steps Required for the Installation of the 3.5” x 5” Cool Boot Top Air Sealing Fitting
Step 1: Disengage the hook and loop cinch tie
and the hook and loop strips along the top edge
and side of the fabric sleeve. Open the fitting to
accept the existing cable bundle by separating
the end of the fitting assembly.
Step 2: Place the fitting around the cable bundle.
Step 3: Reattach the hook and loop side strip and
the cinch tie. Align Cool Boot fitting with the
cabinet top bezel and insert by pressing down on
the top of the outer edges of the fitting assembly.
Step 4: Reattach the hook and loop at the top
edge of the fabric sleeve. Pull the hook and loop
cinch tie tight around the cable bundle. Wrap
cinch tie around the cable bundle and attach it to
itself. If applicable, trim off the excess cinch tie
material.
1 2 3
4
Page 2 of 2
Loading...