Page 1
Cabinet Top Cover & Cable Protection
Part Number(s) : CTCN6X6
© Panduit Corp. 2016
INSTALLATION INSTRUCTIONS
CTCN6X6
V00029HY
Tin snips or
wire cutters
1
Step 1: Using tin snips
or wire cutters, cut the (8)
tabs and remove cut-out
from top of cabinet.
2
Step 2: File down any burrs left
behind from cutting tabs of cut-out.
Hand File
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
Page 2
© Panduit Corp. 2016
INSTALLATION INSTRUCTIONS
V00029HY
3
REMOVE TOP CAP FROM BEZEL
4
INSERT BEZEL INTO TOP OF CABINET
-Insert bezel into cabinet top cap by snapping into place
over each latch. Visually inspect to ensure all latch tabs
have engaged below the opening. Then apply moderate
forces in the upward direction to ensure the part is
secured into the cabinet top cap.
5
INSERT TOP COVER
-Insert one side of cover, lengthwise, into bezel. Then pivot
the other down, snapping the cover into place.
1
2
6
SECURE TOP COVER
-Using the nger pull, apply moderate forces in any
direction to ensure the part is secured into the
cabinet top cap. Repeat steps 1 thru 6 as needed.
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 2 of 2
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Loading...