Page 1
CT-310
C
T
-
3
1
0
2
2-18
0,5-1,0
16-14
1
,5-2,5
1
2-10
4
,0-6,0
P/N94130
Crimp
Direction
1/16
1/32
Crimp Area
Crimp
Direction
Crimp
Area
CRIMPING TOOL
OPERATION
CT-310
CRIMPING TOOL OPERATION INSTRUCTIONS
© Panduit Corp. 2016
PMPI101
REV: 03 12-2016
INSTRUCTIONS
WARNING:
Electric Shock Hazard:
Do NOT use this tool
on live wire.
Verify power is “OFF” before
working on wiring with this tool.
The plastic grips are for the user’s comfort,
and are not intended to insulate against
electrical shock while working on
live electrical circuits.
Insulated Terminal Instructions
1. Locate terminal in proper size die with edge of
die 1/16” from front end of insulation. Insure
crimp is perpendicular to the plane formed by
the ring end terminal.
2. Insert stripped wire into terminal until a
minimum of 1/32” of c onductor extends
beyond barrel.
3. Squeeze the handles firmly until
ratchet releases.
4. Heat insulation with a heat gun or open flame
until fully shrunk.
Crimping Dies
for Panduit Heat
Shrink insulated
terminals, disconnects
& splices with #22 to
#10 AWG CU wire.
Ratchet
Device
to assure full cycle
terminations.
Covered
Handles
for better gripping
and comfort.
Butt Splice Instructions
1. Locate splice in proper crimp pocket.
Center the crimp pocket over one-half of
the barrel.
2. Insert stripped wire into crimp barrel.
3. Squeeze the handles firmly until
ratchet releases.
4. Repeat for the other side of splice.
5. Heat insulation with a heat gun or open
flame until fully shrunk.
Disconnect Instructions
1. Locate the disconnect in the proper crimp
pocket. Center the crimp die over the crimp
barrel. Ensure crimp is in direction shown.
2. Insert stripped wire into crimp barrel.
3. Squeeze the handles firmly until ratchet
releases.
4. Heat insulation with a heat gun or open
flame until fully shrunk.
See Page 2 for
Crimp Die Go/No Go
Crimp Chart
E-mail:
techsupport@panduit.com
Technical Support:
1-800-777-3300
www.panduit.com
Page: 1 of 2
Page 2
© Panduit Corp. 2016
Table 1
DIE CLOSURE GO / NO GO GAGE MEMBERS - TOOL NO. CT-310
CRIMP
POCKET
AWG / mm
2
ENGLISH GO / NO GO GAGE MEMBERS METRIC GO / NO GO GAGE MEMBERS
“G” Dia. (GO) “NG” Dia. (NO GO) “G” Dia. (GO) “NG” Dia. (NO GO)
.078" .090" 1,98 mm 2,29 mm22-18 /
0,5-1,0
.098" .110" 2,48 mm 2,79 mm
12-10 / 4,0-6,0 .139" .151" 3,53 mm 3,84 mm
16-14 /
1,5-2,5
OPERATION INSTRUCTIONS
TROUBLESHOOTING
DIE CLOSURE INSPECTION
ie closure is measured by using GO/NO GO gage members (dimensions listed in Table 1 below.
D
CT-310
Page: 2 of 2
Loading...