Page 1
Waterfall Accessories
Part Numbers: CMWB, CMWW
© Panduit Corp. 2014
Rung
Stringer
Figure 1
Ladder Rack
INSTALLATION INSTRUCTIONS CMW-INST
Figure 2
Cable tie windows
for stringer mounting only
Latch
Figure 3
Waterfall Wing (CMWW)
Male attachment
slides
Cable tie windows
for attachment to rack
Tak-Ty Slots
Female attachment slots
Waterfall Base (CMWB)
1) Mount waterfall base (Figure 2) to stringer or rung (Figure 1) with three Panduit PLT
Cable Ties (supplied). Refer to Picture 1 and 2 below.
2) Slide the male attachment slides of the waterfall wing (Figure 3) from above into the
female attachment slots on the outside edge of the waterfall base (Picture 3).
Note: The waterfall wing can be used for bend radius control on either the right or left
side of the base.
3) Route cable from the ladder rack through the waterfall (Picture 4). The cable tie slots
found on the lower portion of the base can be used to secure the cable with a maximum
3/4" Tak-Ty Hook & Loop Cable Tie.
4) If required, mount additional bases to ladder rack rung or stringer to provide additional
lengths of bend radius control (Picture 5).
Picture 1 Picture 2 Picture 3 Picture 4 Picture 5
For instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Rev. 05Page 1 of 1
Loading...