Page 1
Mini-Com BAS Connector Module
INTRODUCTION
The Mini-Com BAS Connector Module screw-down type connector is designed for use
with 18 - 22 AWG three conductor shielded cable consisting of (1) positive, (1) negative
and (1) ground. It is best to use cable recommended by the device manufacturer and
follow their installation instructions.
RECOMMENDED TOOLS
- 3mm slotted screwdriver
- Wire cutters
- Wire strippers
- Cable stripper
CMBRS485**
3/8"
Rip cord
1 - Negative Conductor
1 - Positive Conductor
1 - Ground
1"
Shield
STEP 1
Cable Preparation
Part Number: CMBRS485**
© Panduit Corp. 2014
INSTALLATION INSTRUCTIONS
PN427C
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
Page 2
© Panduit Corp. 2014
STEP 3
Before inserting wires for termination,
turn screws counter-clockwise
to ensure
all clamps are completely open.
(See Fig. 1)
With cable prepared, insert the three
individual wires into the three open slots
on the back of the connector.
Turn screws clockwise
to ensure all
clamps are properly closed and wires
are secure.
Terminate the field controller cable to the
plug in the same manner. Be sure to
align the wires as straight pass-through.
Fig. 1
HALF
CLOSED
OPEN
OPEN
To field
controller
To m a st e r
controller
STEP 2
The connector and plug are
configured for the electrical signal
to be a straight pass-through.
Be sure to connect positive to
positive, negative to negative and
ground to ground.
A
B
C
A
B
C
AA
BB
CC
Plug
Connector
INSTALLATION INSTRUCTIONS PN427C
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 2 of 2
techsupport@panduit.com
E-mail:
Phone:
866-405-6654
Loading...