Page 1
Network Cable Manager - Active Equipment
MANAGER
UTP Cable
.187 Dia
per RU
CMBRC5
24
CMBRC5E
48
© Panduit Corp. 2014
CMBRC5
CMBRC5E
CABLE CAPACITY
For Horizontal Cards and N
Part Numbers: CMBRC5, CMBRC5E
ETFRAME
INSTRUCTIONS CM276B
Rack Mounting
Active Equipment
CMBRC5, CMBRC5E (shown)
Use screws provided with active equipment to mount CMBRC5 or CMBRC5E on rack
over the active equipment by loosening screws so edge of manager can slide under the
screwhead, then retighten screws.
When routing the cables from the active equipment into the manager, either of the following two methods is recommended
to help maintain cable bend radius.
METHOD 1: Route half of the cables from the active equipment cards horizontally through the finger spaces into the
vertical pathway. Repeat process for the other half of the cables routing them in the opposite direction.
METHOD 2: Route all cables in one direction from the cards horizontally through the finger spaces into the vertical pathway.
METHOD 1
Finger
Spaces
Horizontal
Card
Active Equipment
METHOD 2
Finger
Spaces
Horizontal
Card
Active Equipment
For Worldwide Subsidiaries
and Sales Offices visit
Web Site: www.panduit.com
Page 1 of 1
Technical Support Phone: 866-405-6654
Fax: 708-444-6993
E-mail: ncginfo@panduit.com
Loading...