Page 1
Mini-Com Binding Post Module
A
D
C
D
C
Speaker wire
B
A
C
A
D
Part Numbers: CMBPR**Y, CMBPB**Y
© Panduit Corp. 2014
Option 1
A. Strip off about 1/2" to 3/4" of outer jacket
from the speaker wire. Twist
strands together.
B. Remove termination cap from front side
of module by rotating counter-clockwise.
C. Insert the exposed portion of the speaker
wire into the side hole in the binding post
shaft.
D. Re-install termination cap by rotating
clock-wise until wire is secure.
conductor
INSTALLATION INSTRUCTIONS
Ring
Front
Rear
CMBPR**Y, CMBPB**Y
(R = Red colored ring)
(B = Black colored ring)
Installation Options for Front of Module
Option 2
A. Strip off about 1/2" to 3/4" of outer jacket
from the speaker wire. Twist
strands together.
B. Remove termination cap from front side
of module by rotating counter-clockwise.
C. Curve exposed wire slightly. Wrap wire
around the shaft.
D. Re-install termination cap by rotating
clock-wise until wire is secure.
conductor
Option 3
A. Insert banana plug straight into the
PN334B
shaft on the front side of module.
Installation Options for Rear of Module
Option 1
A. Remove set screw from rear shaft.
B. Insert banana plug straight into the shaft
on the rear side of module.
C. Discard set screw.
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 1 of 1
Option 2
A. Remove set screw
from rear shaft.
B. Strip off about 1/2" to
3/4" of outer jacket
from the speaker
wire. Twist conductor strands together.
techsupport@panduit.com
C. Insert exposed
wires into shaft
on the rear side
of module.
D. Replace screw
and tighten until
wire is secure.
E-mail:
Phone:
866-405-6654
Loading...