Page 1
Mini-Com Solder Type Connectors
Part Numbers: CMRCAR**, CMRCAY**, CMRCAW**, CM35MSS**
© Panduit Corp. 2014
SOLDER RING
INSTALLATION INSTRUCTIONS
LOCKWASHER
90°
RCA Module
NUT
GROUND WIRE
PN190F
STEP ONE
A. SLIDE SOLDER RING, LOCKWASHER, AND NUT
ONTO SIGNAL WIRE.
B. PULL SIGNAL WIRE THROUGH MODULE.
C. LOOP WIRE THROUGH HOLE IN RCA AND TWIST.
D. SOLDER WIRE TO BACK OF RCA.
STEP TWO
A. ASSEMBLE SOLDER RING, LOCKWASHER, AND
NUT TO RCA-MODULE SUBASSEMBLY.
B. LOOP GROUND WIRE THROUGH SMALL HOLE IN
SOLDER RING AND TWIST.
C. SOLDER GROUND WIRE TO SOLDER RING.
SLEEVE
(Ground)
- long pin
RING (R)
- gold pin
Fig. 1
STEP THREE
A. BEND SOLDER RING TAB 90°.
3.5mm Stereo Module
TIP (L)
A. REFER TO FIG. 1 FOR WIRE PLACEMENT.
B. SOLDER WIRES TO CORRECT TABS ON THE BACK
OF CONNECTOR.
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 1 of 1
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Loading...