Page 1
143NCBOT24K-INS
CBOT24K
Rev. 00 01-2008
CABLE BUNDLE ORGANIZING TOOL INSTRUCTIONS
© Panduit Corp. 2007
The following steps are used for bundling cables starting from the middle of the bundle outwards using two tools.
For starting at the end of the bundle follow the same steps using only one tool.
STEP 1: Select the appropriate insert from the table below. Join two same color inserts together using the pocket
and boss alignment features. Hold the two inserts together before inserting cables.
INSERT INFORMATION
Insert Color Recommended for Cable Outer Diameter Range
Fluorescent
Green
Fluorescent
Yellow
** When using the CBOT24K on 10 Gigabit cables, it is recommended that PANDUIT 10GIG™ Category 6A cables be used for optimum performance of installed cable.
0.180" - 0.248"
4.57mm - 6.30mm
0.230" - 0.310"
5.84mm - 7.87mm
STEP 2: Insert cables, one at a time, into the two inserts while holding them together.
STEP 3: Once all cables are installed, the inserts can be separated by pulling them apart. Make sure that no cables
fall out of the inserts during this step.
Insert Used with the Following
PANDUIT Cable Types
TX5500™ Category 5e UTP
TX6000™ Category 6 UTP
TX6500™ Enhanced Category 6
TX6A™ 10G
IG™ Category 6A**
All Shielded Cables
STEP 4: After the inserts are separated, install the hinged jacket around each insert and secure with the attached
hook and loop fastener to secure the assembly. Each of the tools can now be guided in eithe r direction to
organize cables. Apply cable ties at desired intervals as you move along the cable bundle length.
Note: When complete slide reusable tool off of cable bundle
Website: www.panduit.com
Email: cs@panduit.com
Page: 1 of 1
For more information:
Tel.: 800-777-3300
Loading...