PA25770A01
6
1. Move the Back Handle away as
2. Turn the Tension all the way
3. Flip the tool over and remove
4. Remove the Mandrel and put it
5. Remove the Ratchet and put it
BT2HT, BT2HTI & RT2HT
HANDLE SPRING REPLACEMENT INSTRUCT IONS
Rev. 02 8-201
© Panduit Corp. 2016
Handle Return Spring part number: TB24796B01
shown.
down.
the E-ring from the Mandrel
and put it aside.
aside.
aside.
Page: 1 of 2
© Panduit Corp. 2016
6. Push both Bearings inside.
7. Remove the Front Handle.
8. Apply Grease (Versalube G326
9. Slide the Handle back into the Tool Body with Handle Spring.
10. Push the Bearings out to flush with Tool Bodies.
11. Make sure the dot on the
12. Slide the Mandrel in and put the E-ring back on.
or equivalent) on the Handle
Spring and place it around the
smaller Bearing.
BT2HT, BT2HTI & RT2HT
HANDLE SPRING REPLACEMENT INSTRUCTIONS
Ratchet is towards you. Slide
the Ratchet in.
techsupport@panduit.com
www.panduit.com/emea
EU Email: emeatoolservicecenter
Email:
EU Website:
@panduit.com
Panduit Europe • EMEA Service Center
www.panduit.com
Page: 2 of 2
Tel: +31 546 580 452 • Fax: +31 546 580 441
Almelo, Netherlands
Technical Support
Tel: 1-800-777-3300
Loading...