Page 1
INSTALLATION GUIDE
ACE02 or ACE03:
with Card Reader
Cam
Screw
Standard
Stop Disc
Extended
Stop Disc
Top Mounting
Bracket
Bottom Mounting
Bracket
Top Mounting
Screw (14mm)
Bottom Mounting
Screws (25mm)
Electronic Swinghandle with Card Reader
SWINGHANDLE INCLUDED INSTALLATION PARTS
Electronic Swinghandle
Keys
Customer Service: CS@panduit.com 800.777.3300 Technical Support: techsupport@panduit.com 866.405.6654 page 1
IM035 Rev 00
Page 2
INSTALLATION GUIDE
Swinghandle Lock Mounting Option for Front and Rear Door
1. If needed, remove any existing lock mechanism. Save the Cam (latch) for later steps.
NOTE: The Swinghandle’s lock requires a cut-out of 150x25mm. Reference Figure 2 for the following steps. Use a
#1 POZIDRIV driver when securing the mounting screws for Top and Bottom Mounting Brackets.
2. Position the lock body within the cut-out and flush to the outer face of the cabin et door . Use the 14mm Top
Mounting Screw and Top Mounting Bracket to secure the lock to the door.
3. Select a suitable Stop Disc (standard or extended) and mount the cam assembly from Step 1. Secure using the
included Cam Screw. Pay careful attention to the orientation of the Stop Disc according to your installation
requirements.
Figure 1: Swinghandle Inst allat ion onto Cabinet Door
4. Ensure that the orientation of the lock plug corresponds to the orientation of the Bottom Mounting Bracket and
install the Bracket using the included 25mm Bottom Mounting Screws.
Customer Service: CS@panduit.com 800.777.3300 Technical Support: techsupport@panduit.com 866.405.6654 page 2
IM035 Rev 00
Loading...