Panduit ACA01 Installation Manual

Page 1
Customer Service: CS@panduit.com 800.777.3300 Technical Support: techsupport@panduit.com 866.405.6654 page 1
IM022 Rev 01
INSTALLATION GUIDE
ACA01: Door Switch Sensor
Screws
Double-Sided Tape
Cable Ties
Adhesive Backed Mount
Magnet
Magnetic-Switch
Door Switch Sensor (ACA01)
The Door Switch Sensor is designed to send a notification when the door on which it is This provides added security. Installation of the further facilitated by using a quick disconnect coupler and standard ethernet cable (sold separately) that allow for
convenient positioning of sensors, movement of equipment, and an easy disconnect method for removing rack
the enclosure doors.
Note: The Door Switch Sensor is only designed to connect to a G5 iPDU. Connecting it to another device may
in damage.
result

INVENTORY

installed has been opened.
Door Switc h Se nsor and ongoing equipment maintenance is
Page 2
Customer Service: CS@panduit.com 800.777.3300 Technical Support: techsupport@panduit.com 866.405.6654 page 2
IM022 Rev 01
INSTALLATION GUIDE
Quick Disconnect Coupler
Standard Ethernet Cable (2 meters)
Panduit Full-Door
Panduit Split-Door
Magnetic Sensors

OPTIONAL ACCESSORIES

Panduit PN: CC5E88BL Panduit PN: UTP28CH2MBL
Mounting Kit for Magnetic Sensors
Mounting Kit for
Panduit PN: MA015 Panduit PN: MA016
Page 3
Customer Service: CS@panduit.com 800.777.3300 Technical Support: techsupport@panduit.com 866.405.6654 page 3
IM022 Rev 01
INSTALLATION GUIDE
INSTALLATION INSTRUCTIONS
NOTE: The remainder of this guide demonstrates installation into a Panduit cabinet. Pay careful attention to the part numbers and location of each item. Adaptation to the installation locations/method may be required for other cabinets. It is also assumed that the G5 iPDU is located at the rear of the cabinet.
NOTE: For ease of installation of the magnetic switch and magnet in Panduit cabinets, use Full-Door Sensor Brack et Kit (Panduit PN: MA015) or Split-Door Sensor Bracket Kit (Panduit PN: MA016). Installation instructions and hardware are included with the bracket kits.
1. Attach the Door Switch Sensor’s magnet to the top corner of the cabinet using double-sided tape, screws, or optional bracket hardware. See Figure 1.
2. Attach the Door Switch Sensor’s magnetic switch to the top corner of the cabinet door opposite the magnet using double-sided tape, screws, or optional bracket hardware. See Figure 1. Route and secure the cable to the cabinet door using the included adhesive backed mount and cable ties as needed.
NOTE: The operating distance between the Magnetic Switch and the Magnet is dependent on the installation. In a typical installation the distanc e between the Magnetic Switch and Magnet should be less than 10mm when the cabinet door is in the closed position. Greater distances may cause the G5 iPDU to read the door as “OPEN”.
Figure 1: Door Switch Sensor's Magnetic Switch and Magnet Placement
3. Plug the Door Switch Sensor into an available Sensor port on the G5 iPDU.
4. The Door Switch Sensor’s status can be read from the iPDU’s display or when viewing the web-interface.
5. Access the G5 iPDU Web Interface to manage the Access Security configuration alarms and notification settings.
6. The Door Switch Sensor is now installed and ready to use.
Loading...