Page 1
Notes for installation:
• For best results,
PANDUIT
rubber adhesive mounts should be applied to clean, dry, grease-free
surfaces. It is recommended that the surface be cleaned prior to mount installation with a blend
of isopropyl alcohol and water 50/50.
• For proper installation, simply remove the release liner and place the mount in the desired location.
Avoid touching the adhesive prior to positioning the mount. Apply firm pressure to the mount for 5
seconds to insure proper adhesion. Allow the mount to properly dwell.
• Ball-and-socket tether must hang down from the mount with bundle installed below the mount.
• Unsupported bundle length should be no more than 1.27 lbs. (see illustration below, unsupported
bundle length is shown as figure “A”)
• There must be no rigid mounts in line with the dynamic cable manager. These mounts would
restrict bundle motion.
• The mounts should not be placed directly next to the hinge. A suggested minimum of 1" between
edge of part and hinge is recommended.
• Please see below for a comparison of typical current installations using static mounts and suggested
installation using dynamic cable manager mounts
Dynamic Cable Manager
Part number: ABDCM30-A-_
INSTALLATION INSTRUCTIONS for Dynamic Cable Manager (ABDCM-INST)
Rev. 00
Suggested installation using dynamic cable manager mounts
Typical current installations using static mounts
A
For Instructions in Local Languages
and Technical Support:
http://www.panduit.com/resources/install_maintain.asp
E-mail:
cs@panduit.com
Fax:
(708) 532-1811
www.panduit.com
For Technical Support: www.panduit.com/resources/install_maintain.asp
Loading...