Panda MD22 Quick Manual

MD22xx barcode scanner quick guide

 A standard packing includes a scanner, a USB cable and a CD (or a user manual).
 Accessories include a stand, a RS232 cable, a 5V adaptor and a PS/2 cable.
 Use a piece of dry and soft cloth when cleaning the scanner.

Parts of the scanner

① LED

② Exit window

③ Trigger

④ Cable interface port

⑤ Release-hole of the cable

⑥ Beeper

Installing the cable

1. Switch off the host;

2. Refer to the below pictures, connect the host with the scanner based on different cables;

3. Ensure that all connections are secure.

4. Switch on the host system. If installation is successful, the beeper will beep and LED will
light.

USB cable RS232 cable PS/2 cable

Removing the cable

1. Find the release-hole.

2. Insert a thin wire into the hole and pull out the cable gently.

Default value initialization and Fir mwar e version list

Default value initialization

Firmware version list

Programming instruction and exa m ple

Assembling the stand (accessory)

1. See the figure above, tighten the screws.

2. Bend the neck to the desired position for scanning.

Scan “ SETUP

”

Scan “ Option bar code

”

Scan “ the 1 st c h aracter of option

”

Scan “ the 2 nd character of option

”

Scan

“

END

”

Example: to set

Flow control

to be XON/XOFF.

3. Screw mounting: Screw one #10 wood screw into each screw-mount-hole until the base of
the stand is secured.

4. Tape mounting: ①Peel the paper liner off one side of each piece of tape and place the sticky
surface over each of the three rectangular tape holders. ②Peel the paper liner off the
exposed sides of each piece of tape and press the stand on a flat surface until it is secure.

Note: 1. More details refer to User M anual；2. For better readability, please print this document with laser printer. 3. Version:
MD22xx_QG_EN_V1.5.