Temporary Confidential
GT1540_Shinsei.book Page 1 Tuesday, February 13, 2007 3:53 PM
Operating Instructions
Global VoIP Telephone
Model No. BB-GT1540
This unit is compatible with Caller ID. To use this feature, you must subscribe to the appropriate services offered by your landline service provider and VoIP service provider.
Charge the handset battery for 7 hours before initial use.
Please read these Operating Instructions before using the unit and save for future reference.
Temporary Confidential
GT1540_Shinsei.book Page 2 Tuesday, February 13, 2007 3:53 PM
When using the product, basic safety precautions should always be followed to reduce the risk of fire, electric shock, or personal injury.
1.Read all instructions carefully.
2.Follow all warnings and instructions marked on the product.
3.Unplug the product from power outlets before cleaning. Do not use liquid or aerosol cleaners. Use a moist cloth for cleaning.
4.Do not use the product near water, for example near a bathtub, wash bowl, kitchen sink, etc.
5.Place the product securely on a stable surface. Serious damage and/or injury may result if the product falls.
6.Do not cover slots and openings on the product. They are provided for ventilation and protection against overheating. Never place the product near radiators, or in a place where proper ventilation is not provided.
7.Use only the power source marked on the product. If you are not sure of the type of power supplied to your home, consult your dealer or local power company.
8.Do not place objects on the power cord. Install the product where no one can step or trip on the cord.
9.Do not overload power outlets and
extension cords. This can result in the risk of fire or electric shock.
10.Never push any objects through slots in the product. This may result in the risk of fire or electric shock. Never spill any liquid on the product.
11.To reduce the risk of electric shock, do not disassemble the product. Take
the product to an authorized service center when service is required. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the product is subsequently used.
12.Unplug the product from power outlets and take to an authorized service center when the following conditions occur:
A.When the power cord is damaged or frayed.
B.If liquid has been spilled into the product.
C.If the product has been exposed to rain or water.
D.If the product does not work normally by following the operating instructions. Adjust only controls covered by the operating instructions. Improper adjustment may require extensive work by an authorized service center.
E.If the product has been dropped or physically damaged.
F.If the product exhibits a distinct change in performance.
13.During thunderstorms, avoid using telephones except cordless types. There may be a remote risk of an electric shock from lightning.
14.Do not use the product to report a gas leak, when in the vicinity of the leak.
SAVE THESE INSTRUCTIONS
WARNING:
L To prevent the risk of fire or electrical shock, do not expose the product to rain or any type of moisture.
LUnplug the product from power outlets if it emits smoke, an abnormal smell, or makes an unusual noise. These conditions can cause fire or electric
2
Temporary Confidential
GT1540_Shinsei.book Page 3 Tuesday, February 13, 2007 3:53 PM
shock. Confirm that smoke has stopped emitting and contact the Panasonic Call Center at 1-800-211- PANA (1-800-211-7262).
L Do not spill liquids (detergents, cleansers, etc.) onto the telephone line cord plug, or allow it to become wet at all. This may cause a fire. If the telephone line cord plug becomes wet, immediately pull it from the telephone wall jack, and do not use.
L Do not place or use this product near automatically controlled devices such as automatic doors and fire alarms.
Radio waves emitted from this product may cause such devices to malfunction resulting in an accident.
L Completely insert the AC adaptor/power plug into the power outlet. Failure to do so may cause electric shock and/or excessive heat resulting in a fire.
L Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it from the power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation defect from moisture, etc. resulting in a fire.
CAUTION:
Installation
LNever install telephone wiring during a lightning storm.
L Never install telephone line jacks in wet locations unless the jack is specifically designed for wet locations.
L Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.
L Use caution when installing or modifying telephone lines.
L Do not touch the plug with wet hands.
L The AC adaptor is used as the main disconnect device. Ensure that the AC outlet is installed near the product and is easily accessible.
Battery
To reduce the risk of fire or injury to persons, read and follow these instructions.
L Use only the battery(ies) specified. L Do not dispose of the battery(ies) in a
fire. They may explode. Check with local waste management codes for special disposal instructions.
L Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.
L Exercise care when handling the battery(ies). Do not allow conductive materials such as rings, bracelets or keys to touch the battery(ies), otherwise a short circuit may cause the battery(ies) and/or the conductive material to overheat and cause burns.
L Charge the battery(ies) provided, or identified for use with the product only, in accordance with the instructions and limitations specified in this manual.
Medical
L Consult the manufacturer of any personal medical devices, such as pacemakers or hearing aids, to determine if they are adequately shielded from external RF (radio frequency) energy. (The product operates in the frequency range of 5.74 GHz to 5.84 GHz, and the power output is 200 mW (max.).) Do not use the product in health care facilities if any regulations posted in the area instruct you not to do so. Hospitals or health care facilities may be using
3
Temporary Confidential
GT1540_Shinsei.book Page 4 Tuesday, February 13, 2007 3:53 PM
equipment that could be sensitive to external RF energy.
No responsibility will be taken by our company with respect to consequences resulting from the inappropriate use, damage or both of the unit.
Base unit location/avoiding noise
The base unit and other compatible Panasonic units use radio waves to communicate with each other.
L For maximum coverage and noisefree communications, place your base unit:
–at a convenient, high, and central location with no obstructions between the handset and base unit in an indoor environment.
–away from electronic appliances such as TVs, radios, personal computers, wireless devices or other phones.
–avoid facing radio frequency transmitters, such as external antennas of mobile phone cell stations (avoid putting the base unit on a bay window or near a window).
L Coverage and voice quality depends on the local environmental conditions.
LIf the reception for a base unit location is not satisfactory, move the base unit to another location for better reception.
Environment
LKeep the product away from electrical noise generating devices, such as fluorescent lamps and motors.
L The product should be kept free from excessive smoke, dust, high temperature, and vibration.
LThe product should not be exposed to direct sunlight.
L Do not place heavy objects on top of the product.
L When you leave the product unused for a long period of time, unplug the product from the power outlet.
LThe product should be kept away from heat sources such as heaters, kitchen stoves, etc. It should not be placed in rooms where the temperature is less than 5 °C (41 °F) or greater than 40 °C (104 °F). Damp basements should also be avoided.
LThe maximum calling distance may be shortened when the product is used in the following places: Near obstacles such as hills, tunnels, underground, near metal objects such as wire fences, etc.
L Operating the product near electrical appliances may cause interference. Move away from the electrical appliances.
Routine care
L Wipe the outer surface of the product with a soft moist cloth. Do not use benzine, thinner, or any abrasive powder.
4
Temporary Confidential
GT1540_Shinsei.book Page 5 Tuesday, February 13, 2007 3:53 PM
Connecting to a landline and the Internet (IP line)
Connect the base unit to a broadband router or modem with a built-in router. *1 Computer is not required for setup or making/answering internet calls.
Hook |
(120 V AC, 60 Hz)
|
|
3 |
Internet |
|
|
AC adaptor |
|
|
|
Router |
|
|
|
|
Cable or |
|
|
|
DSL modem |
|
|
Ethernet cable |
|
1 |
2 |
Computer |
|
|
|
||
|
|
|
|
Telephone |
|
(optional) *1 |
|
|
|
|
|
line cord |
|
|
Public Switched |
|
|
To single-line |
Telephone |
|
|
telephone jack |
Network |
|
|
(RJ11C) |
|
1Connect the included telephone line cord until it clicks into the “TEL” port on the base unit and telephone line jack.
2Connect the included Ethernet cable to the “LAN” port on the base unit and unused Ethernet (LAN) port on your router or modem with a built-in router.
3Connect the included AC adaptor to the base unit by pushing the plug firmly, then plug the other end into the power outlet.
L Use only the included Panasonic AC adaptor PQLV203.
L The STATUS indicator on the base unit flashes once in red.
5