Panasonic PT-RZ575U Datasheet

PEC

Product Number : PT-RZ575

ILE

Product Name : 1-Chip DLP

™

Projectors

As of A ugust 2 016 . Specificat ions and appear an ce are subject to change without not ic e.

SFD16M37

1/11

1-Chip DLPTM Projector

Specications

Main unit

Power supply Power consumption

BTU value DLP™ chip Panel size

Display method

Pixels Lens Light Source

Screen size Brightness*

Center-to-corner uniformity* Contrast* Resolution

Scanning frequency

HDMI/DVI-D

RGB

(YCBCR)

BPR

Video/S-Video

PT-RZ575

AC100 - 240V 50Hz/60Hz 500W (520VA) NORMAL: 375W ECO: 350W SILENT: 350W

LONG LIFE1: 220W LONG LIFE 2: 185W LONG LIFE 3: 160W

SHUTTER: 40W *Operating Temperature: 25 °C (77 °F),

Altitude: 700m (2,297ft), ICE627087: 2008 Broadcast contents,

Picture mode: Standard, Dynamic contrast [ON]

0.5 W with STANDBY MODE set to ECO*

10 W with STANDBY MODE set to Normal (22 W with STANDBY MODE in

AUDIO SETTING set to ON andQUICK STARTUP function disabled,

50 W with QUICK STARTUP function enabled). Max 1,706 BTU

17.0 mm (0.67 in) diagonal (16:10 aspect ratio) DLP™ chip × 1, DLP™ system 2,304,000 (1920 × 1200) × 1, total of 2,304,000 pixels Fixed-Focus Lens (0.8:1), Auto focus, F 1.75, f 11.9 mm Laser Diode Laser class 1

Luminance life for set: 20,000 hours at half luminance (NORMAL/SILENT)/ 24,000 hours at half luminance (Eco) * Temperature: 35°C (95°F), Altitude 700m (2,297ft), Dust: 0.15mg/m

43,800 hours at constant luminance (LONG LIFE1)

61,320 hours at constant luminance (LONG LIFE2)

87,600 hours at constant luminance (LONG LIFE3)

1.02– 7.62 m (40–300 inches)

5,200 lumens (Center)*2/ 5,000 lumens*2 (NORMAL)

4,160 lumens (Center) / 4,000 lumens (ECO/SILENT)

2,200 lumens (Half luminance) / 1,600 lumens (Constant luminance) (LONG LIFE1)

1,700 lumens (Half luminance) / 1,300 lumens (Constant luminance) (LONG LIFE2)

1,300 lumens (Half luminance) / 1,000 lumens (Constant luminance) (LONG LIFE3)

90% 20,000:1(full on/full off, dynamic contrast ON) 1920 × 1200 pixels

fH: 15- 100kHz, fV: 24 - 120Hz, dot clock: 25 - 162 MHz 525i (480i)*

, 625i (576i)*3, 525p (480p), 625p (576p), 750 (720)/60p, 750 (720)/50p, 1125 (1080)/60i, 1125 (1080)/50i, 1125 (1080)/25p, 1125 (1080)/24p, 1125 (1080)/24sF, 1125 (1080)/30p, 1125 (1080)/60p, 1125 (1080)/50p, VGA (640 x 400) - WUXGA (1920 x 1200) compatible with non-interlaced signals only

fH: 15- 100kHz, fV: 24 - 120Hz, dot clock: 20 - 162 MHz 525i (480i): f 625i (576i): f 525p (480p): f

15.75 kHz; fV59.94 Hz,

15.63 kHz; fV50 Hz,

H 31.50 kHz; fV 60 Hz,

625p (576p): fH31.25 kHz; fV50 Hz,

750 (720)/60p: f

45.00 kHz; fV60 Hz, 750 (720)/50p: fH37.50 kHz; fV50 Hz, 1125 (1080)/60i: f

H 33.75 kHz; fV 60 Hz,

1125 (1080)/50i: fH 28.13 kHz; fV 50 Hz, 1125 (1080)/25p: fH

28.13 kHz; fV25 Hz, 1125 (1080)/24p: fH27.00 kHz; fV24 Hz,

1125 (1080)/24sF: f 1125 (1080)/30p: f

27.00 kHz; fV48 Hz,

33.75 kHz; fV30 Hz, 1125 (1080)/60p: fH 67.50 kHz; fV 60 Hz, 1125 (1080)/50p: fH

56.25 kHz; fV50 Hz fH: 15.75 kHz, fV: 59.94 Hz [NTSC/NTSC4.43/PAL-M/PAL60]

: 15.63 kHz, fV: 50 Hz [PAL/PAL-N/SECAM]

As of A ugust 2 016 2/11

SFD16M37

1-Chip DLPTM Projector

PT-RZ575

Geometry correction range

Only [KEYSTONE] used

Vertical

keystone

correction

angle α (°)

Horizontal

keystone

correction

angle β (°)

[KEYSTONE] and [CURVED] used together Only [CURVED] used

Vertical

keystone

correction

angle α (°)

Horizontal

keystone

correction

angle β (°)

Min. value

of R2/L2

Min. value

of R3/L3

Min. value

of R2/L2

±25 ±20 ±8 ±8 1.7 4.3 1.0 2.6

[VERTICAL KEYSTONE] (viewed from the side) [HORIZONTAL KEYSTONE] (viewed from above)

Screen

Projection distance Arc radius

Screen

Vertical arc correction (viewed from the side) Horizontal arc correction (viewed from above)

Projection distance Arc radius

Screen

Min. value

of R3/L3

Arc center

Screen

Projection distance Arc radius

Arc center

Screen

Optical axis shift Vertical: -4.4%, +4.4(powered)

Horizontal: -2.1%, +2.1%(powered)

Installation Ceiling/oor, front/rear, 360 degree free installation

Terminals

COMPUTER 1 IN D-sub HD 15-pin (female) × 1 R,G,B: 0.7 Vp-p, 75 ohms, (G: 1.0 Vp-p, 75 ohms for sync on G) HD/VD, SYNC: TTL, high impedance, positive/negative automatic Y, P

B, PR Y: 1.0 Vp-p (including sync signal), PB/PR(CB/CR): 0.7 Vp-p, 75 ohms

Y/C Y: 1.0 Vp-p (including sync signal), C: 0.286 Vp-p, 75 ohms COMPUTER 2 IN/1 OUT D-sub HD 15-pin (female) × 1 R,G,B: 0.7 Vp-p, 75 ohms, (G: 1.0 Vp-p, 75 ohms for sync on G) HD/VD, SYNC: TTL, high impedance, positive/negative automatic Y, P

DVI-D IN

DVI-D 24-pin x 1, DVI 1.0 compliant, compatible with HDCP,

B, PR Y: 1.0 Vp-p (including sync signal), PB/PR(CB/CR): 0.7 Vp-p, 75 ohms

for single link only

HDMI IN 1/HDMI IN 2 HDMI 19-pin ×2, Deep Color, compatible with HDCP,

Audio signal: linear PCM (sampling frequencies: 48 kHz, 44.1 kHz, 32 kHz)

VIDEO IN Pin jack × 1, 1.0 Vp-p, 75 ohms

AUDIO IN 1 Pin jack × 2（L-R）　0.5 Vrms, input impedance: 22 kilohms or more

AUDIO IN 2/AUDIO IN 3 M3 (L, R) × 1, 0.5 Vrms, input impedance: 22 kilohms or more VARIABLE AUDIO OUT M3 × 1 (monitor out, stereo) 0–1.80 Vrms, variable, output impedance: 2.2 kilohms or less

SERIAL IN D‑Sub 9 p × 1, for external control (RS-232C compliant) DIGITAL LINK/LAN RJ-45 x 1, for network, DIGITAL LINK connection (HDBaseT™ compatible), 100Base-TX,compatible with Art-Net, PJLink™ (class 1), Deep Color, HDCP LAN RJ-45 x 1 for network connection 10Base‑T/100Base-TX, compatible with Art-Net, PJLink™ DC OUT USB Type A × 1, for power supply (DC5 V, max 900 mA)

Projection distance Arc radius

As of A ugust 2 016 3/11

SFD16M37

1-Chip DLPTM Projector

PT-RZ575

Power cord length Cabinet materials Dimensions (W × H × D)

3.0 m (9 ft 10 in) Molded plastic 498 x 168*

(19-19/32 x 6-5/8*4 x 18-15/16 in ) with supplied lens Weight Operation noise Operating temperature Operating humidity

Approx. 16.6kg (36.6 lbs)

28 dB (Silent), 33 dB (Normal/Eco)

0–45 °C (32–113 °F)*

10%–80% (no condensation)

at less than 4,200 m (13,780 ft.) above sea level Storage temperature

Storage humidity

-20°C–60°C (-4– 140 °F)

10%–80%

Remote control unit

Power supply Operation range

3 V DC (R03/AAA type battery × 2)

Approx. 30 m (98 ft 5 in) when operated from directly in front of the

signal receptor Dimensions (W × H × D)

Weight*

48 × 145 × 27 mm (1-57/64 × 5-45/64 × 1-3/64 in)

Approx. 102 g (3.6 oz) including batteries

Supplied accessories

Power cord with secure lock (x 1) (x 2 for EU models)

Wireless/wired remote control unit (× 1)

Batteries for remote control (R03/AAA type×2)

Software CD-ROM (Logo Tr ansfer Software, Multi Projector Monitoring

& Control Software) (× 1)

Optional accessories

Attachment for ceiling mount bracket Ceiling mount bracket

ET-PKD130B

ET-PKD120H (for high ceilings)

ET-PKD120S (for low ceilings) Early Warning Software Digital interface box Digital Switcher

ET-SWA100*

ET-YFB100G

-YFB200G

D-Sub/S-VIDEO conversion cable ET-ADSV

x 481mm

* The symbol at the end of the part number will vary depending on the type of license.

*1 When the STANDBY MODE is set to Eco, network functions such as power on over the LAN will not operate *2 Measurement, measuring conditions, and method of notation all comply with ISO 21118 international standards *3 Only compatible with dot clock frequency of 27 MHz (pixel repetition signal) *4 with legs at shortest position *5 Average value. May differ depending on models *6 The operating environment temperature should be between 0°C (32°F) and 40°C (104°F) if the projector is used at an altitude between 1,400m (4,593ft) and 4,200m (13,780ft) above sea level. When the OPERATING MODE is set to [ECO] or [SILENT], the projector cannot be used at an altitude of 2,700m (8,858ft) or higher above sea level.

As of A ugust 2 016 4/11

SFD16M37

+ 7 hidden pages