Panasonic PT-DZ6710, PT-DZ6710L User Manual

< 1 >

S PEC F ILE

Product Number : PT-DZ6710/DZ6710L

Product Name : DLP

™

Projectors

As of February 2009. Specifications subject to change without notice.

The PT-DZ6710L is not equipped with a lens.

S PEC F ILE

PT-DZ6710/ DZ6710L

DLP™Projectors

As of February 2009 < 2 >

Specifications

Main Unit

Power supply: North America:

Europe:

Power consumption: North America:

Europe:

DLP™ chip: Panel size:

Display method: Pixels:

Lens: PT-DZ6710:

PT-DZ6710L: Lamp: Screen size: Brightness*

: Center-to-corner uniformity*2: Contrast*2:

Resolution: Scanning frequency: RGB/DVI-D:

YPBPR (YCB CR):

S-Video/Video:

Optical axis shift: Keystone correction range:

Installation: Terminals*3: SDI IN:

DVI-D IN:

120 V AC, 50/60 Hz 220–240 V AC, 50/60 Hz 820 W (880 VA) (Standby mode eco*1: 0.2 W, Standby mode normal: 8 W. Both with fan stopped.) 800 W (960 VA) (Standby mode eco*

: 0.3 W, Standby mode normal:

9 W. Both with fan stopped.)

0.67˝ diagonal (16:10 aspect ratio) DLP™ chip x 1, DLP™ system 2,304,000 (1,920 x 1,200) x 1, total of 2,304,000 pixels Powered zoom/focus lenses (1.8– 2.4:1), F 1.7– 2.0, f 26.8– 35.7 mm Optional poweredzoom/focus lenses 300 W UHM lamps (x 2) (dual lamp system) 50– 600 inches (50– 200 inches with the ET-DLE055), 16:10 aspect ratio 6,000 lumens (dual lamp, high power mode) 90% 2,000:1 (full on/full off, contrast mode: high, brightness: 3,000 lumens) 1,000:1 (full on/full off, contrast mode: normal) 1,920 x 1,200 pixels Horizontal: 15–91 kHz, Vertical: 50– 85 Hz, Dot clock: 162 MHz or lower 525i (480i): f

H 15.75 kHz; fV 60 Hz,

625i (576i): fH 15.63 kHz; fV 50 Hz, 525p (480p): fH 31.50 kHz; fV 60 Hz, 625p (576p): fH 31.25 kHz; fV 50 Hz, 750 (720)/60p: fH 45.00 kHz; fV 60 Hz, 750 (720)/50p: fH 37.50 kHz; fV 50 Hz, 1035/60i: fH 33.75 kHz; fV 60 Hz, 1125 (1080)/60i: fH 33.75 kHz; fV 60 Hz, 1125 (1080)/50i: fH 28.13 kHz; fV 50 Hz, 1080/25p: fH 28.13 kHz; fV 25 Hz, 1080/24p: fH 27.00 kHz; fV 24 Hz 1080/24sF: fH 27.00 kHz; fV 48 Hz, 1080/30p: fH 33.75 kHz; fV 30 Hz 1080/60p: fH 67.50 kHz; fV 60 Hz, 1080/50p: fH 56.25 kHz; fV 50 Hz Horizontal: 15.75/15.63 kHz, Vertical: 50/60 Hz, (NTSC, NTSC4.43, PAL, PAL60, PAL-N, PAL-M, SECAM) Vertical: +50% (powered), horizontal: ±10% (powered) Vertical: ±40°(±30° with the ET-DLE055).

When using only the KEYSTONE correction of the Geometric

Adjustment function: Vertical ±40°, horizontal ±15° (vertical ±30° and horizontal ±15° with the ET-DLE055).

When using both the KEYSTONE and CURVED corrections of the

Geometric Adjustment function: Vertical ±5°, horizontal ±5° (vertical ±10° and horizontal ±10° with the ET-DLE350, and ver-

tical ±10° and horizontal ±5° with the ET-DLE450). Ceiling/floor, front/rear BNC x 1,

SD-SDI signal (YCBCR 4:2:2 10-bit):

SMPTE 259M compliant: 480i, 576i

Single-link HD-SDI signal (YCBCR 4:2:2 10-bit):

SMPTE 292M compliant: 720/50p, 720/60p, 1035/60i, 1080/50i,

1080/60i, 1080/25p, 1080/24p, 1080/24sF, 1080/30p DVI-D 24-pin x 1, DVI 1.0 compliant, HDCP compatible, for single link only

480p, 576p, 720/60p, 720/50p, 1080/60i, 1080/50i, 1080/24p, 1080/24sF, 1080/25p, 1080/30p, 1080/60p, 1080/50p, VGA (640 x 480) – WUXGA*4(1,920 x 1,200), compatible with noninterlaced signals only, dot clock: 25–162 MHz

S PEC F ILE

PT-DZ6710/ DZ6710L

DLP™Projectors

As of February 2009 < 3 >

RGB 1 IN:

R, G, B:

Y, P

B, PR:

RGB 2 IN:

R, G, B:

Y, P B, PR: VIDEO IN: S-VIDEO IN: SERIAL IN: SERIAL OUT: REMOTE 1 IN: REMOTE 1 OUT: REMOTE 2 IN: LAN:

Power cord length: Cabinet materials: Dimensions (W x H x D): PT-DZ6710:

PT-DZ6710L:

Weight: PT-DZ6710:

PT-DZ6710L:

Operating temperature: Operating humidity:

Remote Control Unit

Power supply: Operation range*7: Dimensions (W x H x D): Weight:

Supplied Accessories

Optional Accessories

Zoom lens (1.3– 1.9:1) Zoom lens (2.3– 3.6:1) Zoom lens (3.6– 5.4:1) Zoom lens (5.4– 8.6:1) Fixed-focus lens (0.8:1) Ceiling mount bracket:

BNC x 5 R: 0.7 Vp-p, 75 ohms, G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms, B: 0.7 Vp-p, 75 ohms HD/VD, SYNC: High impedance, TTL (positive/negative), 75 ohms Y: 1.0 Vp-p (including sync signal), PB/PR: 0.7 Vp-p, 75 ohms

NOTE: HD/SYNC, and VD terminals do not accept tri-leve sync signals.

D-sub HD 15-pin x 1 R: 0.7 Vp-p, 75 ohms, G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms, B: 0.7 Vp-p, 75 ohms HD/VD, SYNC: High impedance, TTL (positive/negative), 75 ohms

NOTE: HD/SYNC, and VD terminals do not accept tri-leve sync signals.

Y: 1.0 Vp-p (including sync signal), PB/PR: 0.7 Vp-p, 75 ohms BNC x 1, 1.0 Vp-p, 75 ohms Mini DIN 4-pin x 1, Y: 1.0 Vp-p, C: 0.286 Vp-p, 75 ohms D-sub 9-pin x 1 (RS-232C compliant) for external controller D-sub 9-pin x 1 for link control M3 jack x 1 for wired remote control M3 jack x 1 for link control D-sub 9-pin x 1 for external control (parallel) RJ-45 x 1 for network connection, 10Base-T/100Base-TX, compliant with PJLink™

3.0 m (9´10˝) Molded plastic 498 mm x 175 mm*5x440mm*6(19-19/32˝ x 6-7/8˝ *5x 17-5/16˝ *6) (with supplied lens) 498 mm x 175 mm*5x 432 mm (19-19/32˝ x 6-7/8˝ *5x 17˝) (without lens) Approx. 16.0 kg (35.3 lbs)(with supplied lens) Approx. 15.2 kg (33.5 lbs)(without lens) 0°–45°C (32°–113°F) 20%–80% (no condensation)

3 V DC (AA battery x 2) Approx. 30 m (98´5˝) when operated from directly signal receptor 51 x 176 x 23 mm (2˝ x 6-15/16˝ x 29/32˝) 134 g (4.7 oz) (including batteries)

Power cord Wireless/wired remote control unit Batteries for remote control (x 2) Wire rope

ET-DLE150 ET-DLE250 ET-DLE350 ET-DLE450 ET-DLE055 ET-PKD56H (for high ceilings) ET-PKD55S (for low ceilings)

Weights and dimensions shown are approximate. Specifications subject to change without notice. *1 In Standby mode eco, LAN-based network functions such as the standby ON function will not operate. *2 Measurement, measuring conditions, and method of notation all comply with ISO 21118 international standards. *3 The HD/SYNC and VD inputs do not accept the tri-level sync signal. *4 WUXGA resolution is supported only when the signals are compliant with VESA CVT-RB (Coordinated Video Timing-Reduced Blanking). *5 With legs at shortest position. *6 Including the supplied lens. *7 Operation range differs depending on environments.

Dimensions

unit : mm (inch) NOTE: This illustration is not drawn to scale. The illustration shows the PT-DZ6710.

S PEC F ILE

PT-DZ6710/ DZ6710L

DLP™Projectors

As of February 2009 < 4 >

Terminals

1 Video input

2 S-Video input

3 RGB 1 input

4 RGB 2 Input

5 DVI-D input

6 LAN connector

7 Remote 1 input

8 Remote 1 output

9 Remote 2 input

10 Serial input

11 Serial output

12 SDI input

423 (16-21/32˝)

440 (17-5/16˝)

17 (21/32˝)

9 (11/32˝)

416 (16-3/8˝)

498 (19-19/32˝)

77.5

(3-1/16˝)20 (25/32˝)

155 (6-3/32˝)

175 (6-7/8˝)

21 (13/16˝)

23 45

G/Y

R/P

S-VIDEO IN

VIDEO IN RGB1 IN RGB2 IN DVI-D I N

LAN

IN OUT

REMOTE 1 REMOTE 2

6 7 8 9 10 11

B/P

IN OUT SERIAL

SYNC/HD

SDI

S PEC F ILE

PT-DZ6710/ DZ6710L

DLP™Projectors

As of February 2009 < 5 >

Standard setting-up position (when installed using the ET-PKD56H)

Upper edge of projected image

256

(10-1/32˝)

Lower edge of projected image

Projected image

340–420

(13-3/8˝–

16-17/32˝)

416–496

(16-3/8˝–

19-17/32˝)

100

(3-15/16˝)

344

(13-17/32˝)

100 (3-15/16˝)

400

(15-3/4˝)

Projected image

unit : mm (inch)

*1 When the lens protrudes to the maxi-

mum. 185 mm (7-9/32˝) with the supplied lens

212 mm (8-11/32˝) with the ET-DLE150 213 mm (8-3/8˝) with the ET-DLE250 219 mm (8-5/8˝) with the ET-DLE350 263 mm (10-11/32˝) with the ET-DLE450 195 mm (7-11/16˝) with the ET-DLE055

*2 Adjustable in 40 mm (1-9/16˝) steps.

CAUTION

The ET-DLE055 has a fixed short-focus lens. Therefore, the lens shift function provided in the main unit cannot be used. If the lens shift function is used, the corners of images may not be displayed or images may remain out of focus in some cases.

+ 10 hidden pages