Panasonic PT-DZ16KU Product Sheet

PEC

SFD14M020

ILE

Product Number :

Product Name :

PT-DZ16K

3-Chip DLP™Projector

As of April 2014. Specifications and appearance are subject to change without notice.

1/14

PT-DZ16K

3-Chip DLP™ Projector

SFD14M020

Specifications

Main unit

Power supply

Power consumption

DLP™chipPanel size

Lens

Lamp

Screen size

Brightness*

Center-to-corner uniformity*

Contrast*

Resolution

Scanning frequency SDI

Display method

Pixels

HDMI/DVI-D/RGB

YPBPR(YCBCR)

Video/S-Video

200–240 V AC, 12 A, 50/60 Hz (3-wire single-phase)

2,150 W (2,200 VA) (0.3 Wwith

STANDBYMODE

set to

NORMAL

.),

STANDBYMODE

set to

max. 7,338 BTU (without light output:7,127 BTU )

24.1 mm (0.95 inches) diagonal (16:9 aspect ratio)

DLP™ chip ×3 (R, G, B), DLP™projection system

2,073,600 (1,920 ×1,080) ×3, total of 6,220,800 pixels

Optional powered zoom/focus lenses

420 W UHM lamps (× 4) (four lamp system)

1.78–25.4 m (70–1,000 inches) (1.78–15.24 m (70–600 inches) with

the ET-D75LE8 tele), (1.78-7.62 m(70 - 300 inches) with the ET-D75LE5, 16:9 aspect ratio

16,000 lumens (four lamp)

90%

10,000:1 (full on/full off, in dynamic iris 3 mode)

1,920 ×1,080 pixels (Input signals that exceed this resolution will be

converted to 1,920 ×1,080 pixels.)

3G-SDI signal (YP

BPR

4:2:2 10-bit):

SMPTE ST 424 compliant: 1080/50p, 1080/60p,

(RGB4:4:4 12bit/10bit):

SMPTE ST 424 compliant: 1080/50i, 1080/60i, 1080/25p, 1080/24p

1080/24sF, 1080/30p

Single-link HD-SDI signal (YP

BPR 4:2:2 10-bit):

SMPTE ST 292 compliant: 720/50p, 720/60p, 1035/60i, 1080/50i,

1080/60i, 1080/25p, 1080/24p, 1080/24sF, 1080/30p

SD-SDI signal (YCBCR 4:2:2 10-bit):

SMPTE ST 259 compliant: 480i, 576i

480p, 576p, 720/60p, 720/50p, 1080/60i, 1080/50i, 1080/25p,

1080/24p, 1080/24sF, 1080/30p, 1080/60p, 1080/50p,

VGA (640 × 480)–WUXGA (1,920 × 1,200), compatible with

non-interlaced signals only, dot clock: 25 –162 MHz

Horizontal: 15 –100 kHz, vertical: 24 –120 Hz, dot clock: 162MHz or less㸦HDMI/DVI-D : 25 MHz– 162MHz)

480i (525i): fH15.73 kHz; fV59.94 Hz,

576i (625i): fH15.63 kHz; fV50 Hz,

480p (525p): fH31.47 kHz; fV59.94 Hz,

576p (625p): f

31.25 kHz; fV50 Hz,

720 (750)/60p: fH45.00 kHz; fV60 Hz,

720 (750)/50p: fH37.50 kHz; fV50 Hz,

1035/60i: fH33.75 kHz; fV60 Hz,

1080 (1125)/60i: fH33.75 kHz; fV60 Hz,

1080 (1125)/50i: f

28.13 kHz; fV50 Hz,

1080/25p: fH28.13 kHz; fV25 Hz,

1080/24p: fH27.00 kHz; fV24 Hz,

1080/24sF: fH27.00 kHz; fV48 Hz,

1080/30p: fH 33.75 kHz; fV 30 Hz,

1080/60p: f

67.50 kHz; fV60 Hz,

1080/50p: fH56.25 kHz; fV50 Hz

fH: 15.73 kHz, fV: 59.94 Hz [NTSC/NTSC4.43/PA L-M/PA L60]

: 15.63 kHz, fV: 50 Hz [PAL/PAL-N/SECAM]

.*19Wwith

ECO

As of April 2014 2/14

PT-DZ16K

3-Chip DLP™ Projector

SFD14M020

Optical axis shift Vertical

Keystone correction range

Keystone correction range when using

both the Keystone and Curved correction of the Geometric Adjustment function

Installation

Terminals SDI IN

Horizontal

HDMI IN

DVI-D IN

RGB 1 IN

R, G, B

Y, P

, PR(Y, CB, CR)

S-Video signal

RGB 2 IN

R, G, B

, PR(Y, CB, CR)

Y, PB

VIDEO IN

SERIAL IN

SERIAL OUT

REMOTE 1 IN

REMOTE 1 OUT

REMOTE 2 IN

LAN

±60% (±50% with the ET-D75LE6) from center of screen, powered

±20% (±15% with the ET-D75LE6) from center of screen, powered

NOTE: Optical axis shift f unction cannot be operated when used with the

ET-D75LE50.

Vertical ±40°, horizontal ±15°

(vertical ±40° and horizontal ±15°with the ET-DLE1/2/10/20, vertical ±22° and horizontal ±15° with the ET-D75LE5/50, vertical ±28° and horizontal ±15° with the ET-D75LE6)

Vertical ±20°, horizontal ±15°

(vertical ±8° and horizontal ±8° with the ET-D75LE5/50,

vertical ±10° and horizontal ±10° with the ET-D75LE6

Ceiling/floor, front/rear

BNC ×1,

3G-SDI signal: SMPTE ST 424 compliant

HD-SDI signal: SMPTE ST 292 compliant

SD-SDI signal: SMPTE ST 259 compliant

HDMI 19-pin ×1, Deep Color, compatible with HDCP,

480i, 576i, 480p, 576p, 720/60p, 720/50p, 1080/60i, 1080/50i,

1080/24p, 1080/24sF, 1080/25p, 1080/30p, 1080/60p, 1080/50p

VGA (640 ×480)–WUXGA*3(1,920 ×1,200),

dot clock: 25 –162 MHz

NOTE: Compatible with non-interlaced signals only.

DVI-D 24-pin ×1, DVI 1.0 compliant, HDCP compatible,

for single link only

480p, 576p, 720/60p, 720/50p, 1080/60i, 1080/50i, 1080/24p,

1080/24sF, 1080/25p, 1080/30p, 1080/60p, 1080/50p,

VGA (640 ×480)–WUXGA*

(1,920 ×1,200),

dot clock: 25 –162 MHz

NOTE: Compatible with non-interlaced signals only.

BNC ×5

R: 0.7 Vp-p, 75 ohms,

G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms,

B: 0.7 Vp-p, 75 ohms

HD, VD/SYNC: TTL, high impedance, positive/negative automatic

NOTE: SYNC/HD and VD terminals do not accept t ri-level sync signals.

Y: 1.0 Vp-p (including sync signal), PB/PR(CB/CR): 0.7 Vp-p, 75 ohms

Y: 1.0 Vp-p, C: 0.286 Vp-p, 75 ohms

D-sub HD 15-pin (female) ×1

R: 0.7 Vp-p, 75 ohms,

G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms,

B: 0.7 Vp-p, 75 ohms

HD, VD/SYNC: TTL, high impedance, positive/negative automatic

NOTE: SYNC/HD and VD terminals do not accept t ri-level sync signals.

Y: 1.0 Vp-p (including sync signal), PB/PR (CB/CR): 0.7 Vp-p, 75 ohms

BNC ×1, 1.0 Vp-p, 75 ohms

D-sub 9-pin (female) ×1 for external control (RS-232C compliant)

D-sub 9-pin (male) ×1 for link control

M3 jack ×1 for wired remote control

M3 jack ×1 for link control

D-sub 9-pin (female) ×1 for external control (parallel)

RJ-45 ×1 for network connection, 100Base-TX/10Base-T, compliant

with PJLink™ (class 1)

As of April 2014 3/14

PT-DZ16K

3-Chip DLP™ Projector

SFD14M020

Power cord length

Cabinet materials

Dimensions (W ×H ×D):

Weight*

Operation noise*

Operating temperature

Operating humidity

Remote control unit

Power supply

Operation range*

Dimensions (W × H × D)

Weight

Supplied accessories

Optional accessories

Zoom lens (0.9–1.1:1)

Zoom lens (1.3–1.7:1)

Zoom lens (1.7–2.4:1)

Zoom lens (2.4 –4.7:1)

Zoom lens (4.6 –7.4:1)

Zoom lens (7.3 –13.8:1)

Fixed-focus lens (0.7:1)

Lens motor cover

Ceiling mount bracket

Frame

Smoke cut filter

Replacement lamp unit

Replacement filter unit

3.0 m (9

10 in)

Molded plastic

620×291*

(24-7/16×11-15/32*

× 800 *5mm

×31-1/2 *5inches) (without lens)

Approx. 43 kg (94.8 lbs) (without lens)

48 dB (quad lamp operation)

0°–45°C (32°–113°F) *

10%–80% (no condensation)

3 V DC (AA/R6 type battery ×2)

Approx. 30 m (98

5 in) when operated from directly in front of the

signal receptor

51 ×176 ×28 mm (2 × 6-15/16 × 1-3/32 inches)

Approx. 134 g (4.7 oz) (including batteries)

Power cord with security lock (× 1)

Wireless/wired remote control unit (× 1)

Batteries for remote control (AA/R6 type ×2)

Software CD-ROM (Logo Transfer Software, Multi Projector Monitoring

& Control Software) (× 1)

ET-D75LE6

ET-D75LE10

ET-D75LE20

ET-D75LE30

ET-D75LE40

ET-D75LE8

ET-D75LE50

ET-D75MC1

ET-PKD510H (for high ceilings)

ET-PKD510S (for low ceilings)

ET-PFD510

ET-SFR510

ET-LAD510 (one bulb)

ET-LAD510F (a set of four bulbs)

ET-EMF510

Weights and dimensions shown are approximate. Specifications and appearance are subject to change without notice.

1When the standby mode is set to eco, network functions such as power on over the LAN network will not operate, and the serial output termi-

nal cannot be used. Also, only certain commands can be received for external control using the serial terminal.

2Measurement, measuring conditions, and method of notation all comply with ISO 21118 intern ational standards.

3WUXGA resolution is supported only when the signals are compliant with V ESA CVT-RB (Coordinated Video Timing-Reduced Blanking).

4 With legs at shortest position.

5 Excluding the optional lens.

6Average value (excluding the optional lens). May diff er depending on m odels.

7 The operating temperature range is 0 °C to 40 °C (32 °F to 104 °F) when the

to 2,700 m (4,593 ft to 8,858 ft) a bove sea level). When the projector is used with the ET-SFR510 Smoke Cut Filter, the operating temperature range is 0 °C to 35 °C (32 °F to 95 °F), and the pr

8 Operation range differs depending on environments.

ojector cannot be used in places at high altitude.

FANCONTROL

is set to

HIGH ALTITUDE MODE

(for altitudes from 1,400 m

As of April 2014 4/14

PT-DZ16K

3-Chip DLP™ Projector

SFD14M020

Dimensions

800 (31-1/2)

730 (28-3/4)

(2-3/4)

244

(9-19/32)

620 (24-13/32)

244

(9-19/32)

unit : mm (inch) NOTE: This illustration is not drawn to scale.

177

(6-31/32)

291 (11-15/32)

(1-27/32)

(1-13/32)

608

(23-15/16)

Terminals

23 45

678910 11 12

1 Remote 1 input

2 Remote 1 output

3 Remote 2 input

4 Serial input

5 Serial o utput

6 SDI input

7 HDMI input

89RGB 1 input

RGB 2 Input

DVI-D input

Video input

LAN connector

As of April 2014 5/14

+ 9 hidden pages