S PEC F ILE
PT-DW5100/ DW5100L
DLP™Projectors
As of January 2009 < 2 >
Specifications
Main Unit
Power supply: North America:
Europe:
Power consumption: North America:
Europe:
DLP™ chip: Panel size:
Display method:
Pixels:
Lens: PT-DW5100:
PT-DW5100L:
Lamp:
Screen size:
Brightness*
1
:
Center-to-corner uniformity*1:
Contrast*1:
Resolution:
Scanning frequency: RGB:
YPBPR (YCB CR):
S-Video/Video:
Optical axis shift:
Keystone correction range:
Installation:
Terminals*2: DVI-D IN:
RGB 1 IN:
R, G, B:
Y, P B, PR:
RGB 2 IN:
R, G, B:
Y, P B, PR:
VIDEO IN:
S-VIDEO IN:
SERIAL IN:
SERIAL OUT:
REMOTE 1 IN:
REMOTE 1 OUT:
REMOTE 2 IN:
LAN:
Power cord length:
Cabinet materials:
120 V AC, 50/60 Hz
220–240 V AC, 50/60 Hz
770 W (770 VA) (10 W during standby mode with fan stopped)
750 W (790 VA) (15 W during standby mode with fan stopped)
0.65˝ diagonal (15:9 aspect ratio)
DLP™ chip x 1, DLP™ system
983,040 (1,280 x 768) x 1, total of 983,040 pixels
Powered zoom/focus lenses (1.8– 2.4:1), F 1.7– 2.0, f 25.6–33.8 mm
Optional poweredzoom/focus lenses
300 W UHM lamps (x 2) (dual lamp system)
50– 600 inches (50 –200 inches with the ET-DLE050 and ET-DLE055),
15:9 aspect ratio
5,500 lumens (dual lamp, high power mode)
90%
2,000:1 (full on/full off, contrast mode: high, brightness: 2,750 lumens)
1,000:1 (full on/full off, contrast mode: normal)
1,280 x 768 pixels
(1,600 x 1,200 pixels compatible, compression mode)
Horizontal: 15–91 kHz, Vertical: 50– 85 Hz,
Dot clock: 150 MHz or lower
480i: fH 15.75 kHz; fV 59.94 Hz, 576i: fH 15.63 kHz; fV 50 Hz,
480p: fH 31.50 kHz; fV 59.94 Hz, 576p: fH 31.25 kHz; fV 50 Hz,
720/60p: fH 45 kHz; fV 60 Hz, 720/50p: fH 37.5 kHz; fV 50 Hz,
1035/60i: fH 33.75 kHz; fV 60 Hz, 1080/60i: fH 33.75 kHz; fV 60 Hz,
1080/50i: fH 28.13 kHz; fV 50 Hz, 1080/60p: fH 67.5 kHz; fV 60 Hz,
1080/50p: fH 56.25 kHz; fV 50 Hz
Horizontal: 15.75/15.63 kHz, Vertical: 50/60 Hz,
(NTSC, NTSC4.43, PAL, PAL60, PAL-N, PAL-M, SECAM)
Horizontal (manual) and vertical (powered),
Horizontal: ±10%, vertical: +60%
Vertical: ±30°
Ceiling/floor, front/rear
DVI-D 24-pin x 1, DVI 1.0 compliant, HDCP compatible, for single link
only
BNC x 5
G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms,
B, R: 0.7 Vp-p, 75 ohms
HD/VD, SYNC: TTL (positive/negative)
Y: 1.0 p-p, 75 ohms (including sync signal), PB/PR: 0.7 Vp-p, 75 ohms
D-sub HD 15-pin x 1
G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms,
B, R: 0.7 Vp-p, 75 ohms
HD/VD, SYNC: TTL (positive/negative)
Y: 1.0 p-p, 75 ohms (including sync signal), PB,/PR: 0.7 Vp-p, 75 ohms
BNC x 1, 1.0 Vp-p, 75 ohms
Mini DIN 4-pin x 1, Y: 1.0 Vp-p, C: 0.286 Vp-p, 75 ohms
D-sub 9-pin x 1 (RS-232C compliant) for external controller
D-sub 9-pin x 1 (RS-232C compliant) for external controller
M3 jack x 1 for wired remote control or link control
M3 jack x 1 for link control
D-sub 9-pin x 1 for external control (parallel)
RJ-45 x 1, compliant with PJLink™, 10Base-T/100Base-TX
3.0 m (9´10˝)
Molded plastic