Panasonic PAN4561L User Manual
Product
New
Introduction
Product
Introduction
NEW! PAN4561L Mesh Networking RF Modules
Designed For Standard Range Applications up to 100 Feet
Panasonic, a worldwide leader in Wireless Products introduces the
NEW PAN4561L Series of Mesh Networking RF Modules. These cost
engineered modules are designed for applications of up to 100 feet
in range where low power consumption is a requirement. PAN4561L
modules are short range alternatives to Panasonic’s original extended
range PAN4561 Series devices.
The PAN4561L Series can be transformed from simple point-topoint proprietary devices to complex mesh networks by choosing
from an array of simple firmware options. Fully featured with 39 I/O
lines, sharing a common 62-pin footprint and software, each model
hosts the FreeScale MC13213 Software-on-a-chip (SOC), using the
same eight-bit GT60 processor as Panasonic’s popular PAN4555
and making the product family application-compatible. Optional Synapse SNAP® firmware provides
a highly flexible, industry-leading solution for mesh networking with a complete network development
environment. Multiple antenna options are available. The Series has FCC, IC, and ETSI certifications.
New
Product Performance:
• Small Size: 35mm x 15mm x 3.5mm
• 3 Antenna Options: Single Port 50Ω, Ceramic
Antenna or SMD Output
• Low Power Modes for Increased Battery Life
• 16 Selectable Channels w/ 250 Kbps (2.4 GHz)
• High Sensitivity: -92 dBm Typical at 1% Packet Error Rate
• Low Supply Voltage: 2.7 V to 3.3 V (3.0 V Typ.)
• Operating Temperature Range: -40˚C to +85˚C
• Link Quality & Clear Channel Assessment Capability
• 60k Flash and 4k RAM Memory
• Two UARTs and One I2C Bus
• 8 Channel A/D Converter with 10 Bit for Fast and
Easy Analog Input Conversion (Temperature,
Pressure and Fluid Levels) to Digital Values
• 5 Channel 16-Bit Timer/Pulse Width Modulation
(Tpm) Outputs
• BDM Port for Direct Download Programming
• 39 Digital I/O Lines with Programmable Pull-Ups and
Several with High-Current Driver
PAN4561L Part Numbers:
Part Numbers Description (all parts 802.15.4) Part Numbers Description (all parts 802.15.4)
ENW-C9A21A1EF Antenna-w/o-Firmware ENW-C9A21A4EF Antenna-SNAP-Firmware
ENW-C9A21B1EF UF.L Connector-w/o-Firmware ENW-C9A21B4EF UF.L Connector-SNAP-Firmware
ENW-C9A21C1EF 50ohm-Pad-w/o-Firmware ENW-C9A21C4EF 50 ohm-Pad-SNAP-Firmware
EVAL_PAN4561 Evaluation Kit for the PAN4561 ENW-C9A30A4EF Eval Module w/ Ceramic Antenna, SNAP-FW
ENW-C9A30B4EF Eval Module w/ UFL Connector, SNAP-FW ENW-C9A30D4EF Eval Module with SMD RF Out, SNAP-FW
www.panasonic.com/rfmodules
piccomponentsmarketing@us.panasonic.com
1-800-344-2112
All Rights Reserved. Specifications are subject to change without notice.
Copyright © 2010 Panasonic Corporation of North America.
PAN4561LNPI, FY10-045-XXX
Dimensions & Pin Layout:
Applications:
• Factory Automation and Control
• Home Gateways/Home Automation
and Control
• Motor/Lighting Control
• Inventory and Logistics Management
• HID (Human Interface Devices)
• Toys
• Remote Control and Wire Replacement
for Industrial Systems (Wireless Sensor
Networks)
• RFID Tagging
• Automated Meter Reading
• Monitoring (Environmental, Patient,
Fitness)
• Proprietary Networking Solutions Using
IEEE802.15.4
Pin No. Pin
1, 22,
32,
53~54,
56~62
2 PTD4 / TPM2CH1
3 PTD5 / TPM2CH2
4 PTD6 / TPM2CH3
5 PTD7 / TPM2CH4
6 PTD2 / TPM1CH2
7, 51~52 NC
8 PTC0 / TXD2
9 PTC1 / RXD2
10 PTC2 / SDA1
11 PTC3 / SCL1
12 - 19 PTB(0~7) / AD1P(0~7)
20 VREFH
21 VREFL
23-24 Vcc
GND
New
Introduction
Product
Introduction
Pin No. Pin
25 PTG1 / XTAL
26 PTG2 / EXTAL
27 RESET
28 CLKO
29 GPIO2
30 PTG0 / BKGND / MS
31 GPIO1
33 VDDA
34 - 41 PTA(7~0) / KBI1P(7~0)
42 PTC7 / GPIO
43 PTC6 / GPIO
44 PTC5 / GPIO
45 PTC4 / GPIO
46 PTE0 / TXD1
47 PTE1 / RXD1
48-50 GPIO(5~7)
55 EXANT
New
Product
Technical Specifications for PAN4561L:
Parameter Value Condition / Notes
Receiver Sensitivity -92 dBm typ. For 1% Packet Error Rate
Transmitter Output Power 0 dBm
Power Supply 2.7 V ~ 3.3 V Single Supply, 3.0 V Typ.
Power Control Range 30 dB
Maximum Data Rate 250 kbps Over The Air
Current Consumption
Receive Mode 45 mA typ.
Transmit Mode 43 mA typ. At 0 dBm
Idle Mode 1.6 mA typ.
Doze Mode 36.3 µA typ. No CLKO
Hibernate Mode 2.2 µA typ.
Off Mode 0.5 µA typ.
Operating Temperature Range -40˚C to +85˚C
www.panasonic.com/rfmodules
piccomponentsmarketing@us.panasonic.com
1-800-344-2112
All Rights Reserved. Specifications are subject to change without notice.
Copyright © 2010 Panasonic Corporation of North America.
PAN4561LNPI, FY10-045-XXX
Loading...