Panasonic PAN1311/21 USB Quick Start Manual
No.
DS-PAN1311/21USB
REV.
1.1
PAGE
1 of 11
Quick Start Guide
Evaluation Board (EVB) PAN1311/21 USB
DATE
15.09.2011
PANASONIC ELECTRONIC DEVICES EUROPE
GmbH
DESIGNED
Erstellt
IW
Quick Start Guide
Evaluation Board (EVB) PAN1311/21 USB
No.
DS-PAN1311/21USB
REV.
1.1
PAGE
2 of 11
Quick Start Guide
Evaluation Board (EVB) PAN1311/21 USB
DATE
15.09.2011
PANASONIC ELECTRONIC DEVICES EUROPE
GmbH
DESIGNED
Erstellt
IW
1. CONTENT
1. Content...................................................................................................................................2
2. Introduction ............................................................................................................................3
2.1 Related documents............................................................................................................... 3
4. Functional overview................................................................................................................3
5. Connection setup ................................................................................................................... 4
5.1 Software start and navigation ............................................................................................... 4
5.2 Port configuration .................................................................................................................5
5.3 Firmware handling................................................................................................................6
5.4 Command tab navigation...................................................................................................... 7
5.5 Creating a connection........................................................................................................... 8
6. Schematic ..............................................................................................................................9
7. Document Information .......................................................................................................... 10
8. General Information..............................................................................................................11
8.1 Waiver................................................................................................................................ 11
9. Life Support Policy ............................................................................................................... 11
No.
DS-PAN1311/21USB
REV.
1.1
PAGE
3 of 11
Quick Start Guide
Evaluation Board (EVB) PAN1311/21 USB
DATE
15.09.2011
PANASONIC ELECTRONIC DEVICES EUROPE
GmbH
DESIGNED
Erstellt
IW
2. INTRODUCTION
This document should provide the minimum knowledge needed to establish a simple
connection between two PAN1321ETU USB Evaluation Boards (EVB) using Infineon
eBMU_SPP_Toolbox software. For this limited information is granted. To learn about all
aspects of the software please refer to the related documents listed below.
2.1 RELATED DOCUMENTS
For further information on Infineon eBMU_SPP_Toolbox software and it’s implemented AT
command set please refer to:
• PAN13x1_ReleaseNote_SPP_AT_SW08_V1.8_RN_Rev1.0_DRAFT
• PAN13x1_ReleaseNote_SPP_AT_SW21_V2.1_RN_Rev1.0_DRAFT -iPhone version
• PAN13x1_SPP_AT_UserManual_SoftwareDescription_Rev5.0 DRAFT
• PAN1321_AN_DesignGuide_Rev2 1
• User's_Manual_PAN1311_V20.xx_Rev1.1
• User's_Manual_PAN1321_V20.xx_Rev3.1
4. FUNCTIONAL OVERVIEW
The figure below shows an overview of the Evaluation Board. If there is the need to connect
your µController to the EVB please de-solder R1, R2, R3, R4.
For more details please refer also to the schematic in chapter Schematic.
Figure 2 : Evaluation Board Overview
Hardware
Reset
UART to USB
Converter Section
For interfaces
description refer to
schematic
Power Supply
section
No.
DS-PAN1311/21USB
REV.
1.1
PAGE
4 of 11
Quick Start Guide
Evaluation Board (EVB) PAN1311/21 USB
DATE
15.09.2011
PANASONIC ELECTRONIC DEVICES EUROPE
GmbH
DESIGNED
Erstellt
IW
5. CONNECTION SETUP
This chapter describes how to use the eBMU_SPP_Toolbox software in order to send simple
data packages from one EVB to the other.
5.1 SOFTWARE START AND NAVIGATION
Browse to the folder where the eBMU_SPP_Toolbox.exe file is located and start it. The user
interface (figure 2) is shown.
Figure 4 : Toolbox start up screen
Loading...