Panasonic NI-860R User Manual

Panasonic

Electric Steam Iron

Operating Instructions

Model NO.N1-760R/NI-761 R/Nl-762R/Nl-762RE/NI-790R/NI-8e0RyNI-861 R/NI'890R

NI-860R

Plea-59 r^ad these instructions carefully before using this product and

save this manual for future use.

For assistance, please call ; 1'800-211-PANA (7262)
or send e-mail to :
or visit us at

For assistance, please call: 787-750'4300
or visit us at www.pana-SOnicpr com (Puerto Rico)

www.panasonic.com (U.S.A)

[e-mail]

IMPORTANT SAFEGUARDS

When using your flatiron, basic safety precautions should always be followed,
including the following:

1. Read all instructions.

2. Use iron only for its intended use.

3. To protect against a risk of electric shock, do not immerse the iron in water
or other liquids.

4. The iron should always be turned to OFF before plugging or unplugging
from outlet. Never yank cord to disconnect from outlet; instead, grasp plug
and pull to disconnect.

5. Do not allow cord to touch hot surfaces. Let iron cool completely before

putting away.

Wind cord into cord reel unit when storing.

6. Always disconnect iron from electrical outlet when filling with water or
emptying and when not in use.

7. Do not operate iron with a damaged cord or if the iron has been dropped
or damaged. To avoid a risk of electric shock, do not disassemble the iron,
take it to a qualified serviceman for examination and repair.

Incorrect reassembly can cause a risk of electric shock when the iron is

used.

8. Close supervision is necessary for any appliance being used by or near
children. Do not leave iron unattended while connected or on an ironing
board.

9. Burns can occur from touching hot metal parts, hot water, or steam. Use
caution when you turn a steam iron upside down-there may be hot water

in the reservoir.

SPECIAL INSTRUCTIONS

1. To avoid a circuit overload, do not operate another high wattage appliance
on the same circuit.

2. If an extension cord is absolutely necessary, a 10 ampere cord should be

used. Cords rated for less amperage may overheat. Care should be taken

to arrange the cord so that it cannot be pulled or tripped over.

SAVE THESE INSTRUCTIONS

© 1995 Matsushita Electric industrial Co., LTD. All rights reserved.

-2-

COMPONENTS IDENTIFICATION

-3-