Panasonic NI-350S User Manual

Panasonic

Electric Steam Iron

Operating Instructions

Model No. NI-350S/N1-350R/NI-552R/NI'553R/NI-560R/NI'R20NR

NI-R15NR/NI-R16NR

N1-552R

Please read these instructions carefully before using this product and
save this manual for future use.

For assistance, please call 1-800-211-PANA f7262)
or send e-mail to : cosumerproducts@pana$onic.com
or visit us at WWW panasonic.com (U.S.A)

For assistance, please call: 787-757-4300

or visit us at WWW panasonicpr.com (Puerto Rico)

IMPORTANT SAFEGUARDS

When using your flatiron, basic safety precautions should always be followed,
including the following:

1. Read all instructions.

2. Use iron only for its intended use.

3. To protect against a risk of electric shock, do not immerse the iron in water
or other liquids.

4. The iron should always be turned to OFF before plugging or unplugging

from outlet. Never yank cord to disconnect from outlet; instead, grasp plug
and pull to disconnect.

5. Do not allow cord to touch hot surfaces. Let iron cool completely before

putting away.
Loop cord loosely around iron when storing. (NI-350S Only)
Wind cord into cord reel unit when storing.

(NI-350R/552R/553R/560R/R20NR/R15NR/R16NROnly)

6. Always disconnect iron from electrical outlet when filling with water or

emptying and when not in use.

7. Do not operate iron with a damaged cord or if the iron has been dropped

or damaged. To avoid a risk of electric shock, do not disassemble the iron,
take it to a qualified serviceman for examination and repair.

Incorrect reassembly can cause a risk of electric shock when the iron is

used.

8. Close supervision is necessary for any appliance being used by or near

children. Do not leave iron unattended while connected or on an ironing
board.

9. Burns can occur from touching hot metal parts, hot water, or steam. Use

caution when you turn a steam iron upside down-there may be hot water
in the reservoir.

SPECIAL INSTRUCTIONS

1. To avoid a circuit overload, do not operate another high wattage appliance

on the same circuit.

2. If an extension cord is absolutely necessary, a 10 ampere cord should be

used. Cords rated for less amperage may overheat. Care should be taken
to arrange the cord so that it cannot be pulled or tripped over.

SAVE THESE INSTRUCTIONS

© 1995 Matsushita Electric industrial Co., LTD. All rights reserved.

-2-

COMPONENTS IDENTIFICATION

NI-350R/552R/553R/R20NR

(This picture is Ni-350R)

NI-560R NI-R15NR/R16NR NI-350S

Jet of Stesm Button/
Vertical Steam Button

-3-