Panasonic KY-E227D, KY-A227D, KY-C227D Installation Instructions Manual

8

Web Site: http://panasonic.net/

© Panasonic Corporation 2014 Printed in Japan

Post-installation Checklist

Upon completing installation, check and mark off the following items.

Checklist Checked

Appearance

• Does the appliance not look like it is tilted to the
front, back, left or right?

• Is the edge of the bottom surface of the top plate not
lifted up?

• Is the top plate clean?

Electrical

Work

• Is the power supply a single phase, 220 V?

• Has the earth been installed?

• Has the earth leakage circuit breaker been installed?

Electrical

testing

1

Touch
to turn the power on.

→ Does the main power light

illuminate?

2

Touch
to start heating.

→ Does the “–” indication

fl ash?

• Make sure to turn off each IH heater and the main power switch after electrical
testing is done.

• Provide the Operating Instructions, Installation Instructions and Guarantee
Certifi cate to the customer.

I hereby certify that installation has been completed.

Signature of installer

ZY16HD88

F0814K0

Installation Instructions

Induction Heating Cooktop

For domestic use

KY-E227D
KY-C227D
KY-A227D

Model No.

ENGLISH

Important

• Install the appliance according to the
Installation Instructions.
Otherwise, the performance of the
appliance may be degraded.

• The installer is responsible for proper
installation.
Malfunctions or accidents resulting from
the failure to follow Installation Instructions
are not covered under the guarantee.

• Make sure to have a qualified gas
technicians (or personnel from gas
company) close the gas valve when
replacing the gas appliances with this unit.

• Do not install an oven under the cabinet.

• Make sure to perform a test run and
explain to the customer how to use the
appliance correctly.

• Provide these Installation Instructions to
the customer for the local electrical
inspector’s use.

Contents

Safety Precautions -------------------------- 2

Dimensions ------------------------------------ 3
Related Dimensions

(Built-in) ---------------------------------------- 4
Installation Location ------------------------- 5

Electrical Work -------------------------------- 6

Installing the Appliance --------------------- 7
Post-installation Checklist ----------------- 8

Ⓗ

101

107

705

380

Intake vent
(1 place on the undersurface)

Φ190

Φ190

181

400

229

742

Exhaust vent

742

380181

400

229

Intake vent
(1 place on the undersurface)

Φ190

Φ150

Exhaust vent

6

18

364

Intake vent

2 3

Safety Precautions

Failure to follow these instructions may cause death or serious injury.

WARNING

• During installation, follow these instructions strictly.

Improper installation may cause electric leakage or fi re.

• Install a 220 V / 20 A dedicated single-phase circuit with an

earth leakage circuit breaker for the power supply.

The electrical wiring may abnormally overheat if the dedicated circuit is not
properly connected.

• Electrical work must be performed by a legally qualifi ed

electrician.

Improper wire connections may cause electric leakage or fi re.

• This appliance must be properly earthed following the

electric laws. The earth conductor must not be connected to
a gas pipe, water pipe, earth of lightning rod and telephone.

Failure to observe this may cause electric shock in case of appliance
breakdown or insulation breakdown.

• Have a qualifi ed electrician earth the appliance.

Improper earthing may cause electric shock.

• Before installation, make sure to turn off the circuit breaker

to prevent electric shock.

• The power cord must be correctly connected to ensure the

integrity of the connection.

Improper wire connections may cause electric leakage or fi re.

• If the power cord is damaged, it must be replaced by the

manufacturer, its service agent or a similar qualifi ed person
in order to avoid a hazard.

• Do not disassemble, repair or modify the appliance (e.g. top

plate).

Doing so may cause abnormal operation of the appliance and may result in
danger.

•

Do not climb on the appliance, or drop heavy items on top of it.

Cracks in the top plate may cause overheating, malfunctions or electric shock.

Failure to follow these instructions may cause injury or property damage.

CAUTION

• Use a heat resistant material for the countertop. However,

do not use a varnished material as they may get discoloured.

The material of the countertop should have heat resistance equal to or higher
than the heat resistance of “laminated thermosetting high-pressure decorative
sheets”. If the materials are not heat resistant, they may get deformed or
cause a fi re.

Dimensions

■ Top view

■ Front view

• KY-A227D • KY-E227D/ KY-C227D

(unit: mm)

•

Power cord length: approx. 1.5 m

■ Side view