Panasonic KX-TGA950 QUICK START GUIDE

Installation Manual

Model No. KX-TGA950

Additional Digital Cordless Handset

Thank you for purchasing a Panasonic product.

This unit is an additional handset compatible with the following series of Panasonic Digital Cordless Phone: KX-TG9541 (The corresponding models are subject to change without notice.) You must register this handset with your base unit before it can be used. This installation manual describes only the steps needed to register and begin using the handset. Please read the base unit’s operating instructions for further details.

Please read this installation manual before using the unit and save it for future reference. For assistance, visit our Web site: http://www.panasonic.com/help for customers in the U.S.A. or Puerto Rico.

One Panasonic Way, Secaucus, New Jersey 07094

Printed in China

PNQX6077ZA

TT0713MU0 (E)

TGA950(en)_0621_ver021.pdf 1 2013/06/21 10:29:34

Accessory information

Supplied accessories

Accessory item/Order number Quantity

Charger/PNLC1040ZB 1

Rechargeable batteries/HHR-55AAABUG 2

Handset cover*1/PNYNTGA680BR

Belt clip/PNKE1268Z1 1

*1 The handset cover comes attached to the handset.

Note:

R Please read the base unit’s operating instructions for additional/replacement

accessories. – Optional headsets: KX-TCA60, KX-TCA93, KX-TCA400, KX-TCA430

Setting up

Connections/Wall mounting

Connect the AC adaptor to the power outlet. Drive the screws (1) (not supplied) into the wall, if necessary.

27.2 mm (1 1/16 inches)

Note:

R The AC adaptor must remain connected at all times. (It is normal for the adaptor

to feel warm during use.)

R Make sure that the wall and the fixing method are strong enough to support the

weight of the unit.

For assistance, please visit http://www.panasonic.com/help

Installation

TGA950(en)_0621_ver021.pdf 2 2013/06/21 10:29:34

Battery installation/Battery charging

Important:

R Use the supplied rechargeable batteries. For replacement, we recommend using

the Panasonic rechargeable batteries noted on page 2.

R USE ONLY Ni-MH batteries AAA (R03) size (A). R Do NOT use Alkaline/Manganese/Ni-Cd batteries. R Confirm correct polarities (

, ).

Charge for about 7 hours.

R Confirm “Charging” is displayed (B). R When the batteries are fully charged, “Fully charged” is displayed.

Note:

R If the batteries are fully charged, but the operating time seems to be shorter,

clean the battery ends (

, ) and the charge contacts with a dry cloth and

charge again.

Registering a handset to a base unit 1 Base unit:

Press and hold MLOCATORN for about 5 seconds. R Depending on the base unit, a registration tone sounds. R If all registered handsets start ringing, press MLOCATORN again to stop,

then repeat this step.

2 Handset:

Place the handset on the base unit or charger, then wait until a long beep sounds and

is displayed.

Note:

R If an error tone sounds, or if

is displayed, register the handset according to

the base unit’s operating instructions.

For assistance, please visit http://www.panasonic.com/help

Installation

TGA950(en)_0621_ver021.pdf 3 2013/06/21 10:29:34

Display language 1 MMENUN#110

2 MbN: Select the desired setting. a MSAVEN a MOFFN

For your safety

To prevent severe injury and loss of life/property, read this section carefully before using the product to ensure proper and safe operation of your product.

WARNING

Power connection

R Completely insert the AC adaptor/power plug into the power outlet. Failure to do

so may cause electric shock and/or excessive heat resulting in a fire.

R Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it

from the power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation defect from moisture, etc. resulting in a fire.

R Unplug the product from power outlets if it emits smoke, an abnormal smell, or

makes an unusual noise. These conditions can cause fire or electric shock. Confirm that smoke has stopped emitting and contact the Panasonic Call Center at 1-800-211- PANA (1-800-211-7262).

Installation

R To prevent the risk of fire or electrical shock, do not expose the product to rain

or any type of moisture.

R Do not place or use this product near automatically controlled devices such as

automatic doors and fire alarms. Radio waves emitted from this product may cause such devices to malfunction resulting in an accident.

CAUTION

Installation and location

R The AC adaptor is used as the main disconnect device. Ensure that the AC

outlet is installed near the product and is easily accessible.

Battery

R We recommend using the supplied batteries or additional/replacement batteries

noted on page 2 for replacement battery information. USE ONLY rechargeable Ni-MH batteries AAA (R03) size.

R Do not mix old and new batteries.

For assistance, please visit http://www.panasonic.com/help

Installation

TGA950(en)_0621_ver021.pdf 4 2013/06/21 10:29:34

R Do not open or mutilate the batteries. Released electrolyte from the batteries is

corrosive and may cause burns or injury to the eyes or skin. The electrolyte is toxic and may be harmful if swallowed.

R Exercise care when handling the batteries. Do not allow conductive materials

such as rings, bracelets, or keys to touch the batteries, otherwise a short circuit may cause the batteries and/or the conductive material to overheat and cause burns.

R Charge the batteries provided with or identified for use with this product only, in

accordance with the instructions and limitations specified in this manual.

R Only use a compatible base unit (or charger) to charge the batteries. Do not

tamper with the base unit (or charger). Failure to follow these instructions may cause the batteries to swell or explode.

Attention:

A nickel metal hydride battery that is recyclable powers the product you have purchased. Please call 1-800-8-BATTERY (1-800-822-8837) for information on how to recycle this battery.

For assistance, please visit http://www.panasonic.com/help

Installation

TGA950(en)_0621_ver021.pdf 5 2013/06/21 10:29:34

+ 11 hidden pages