Panasonic KX-TGA820 User Manual
TGA820(e).fm Page 1 Thursday, June 28, 2007 5:07 PM
Installation Manual
Expandable Digital Cordless Handset
Model No.
Thank you for purchasing a Panasonic cordless telephone.
This unit is an additional handset for use with Panasonic
Digital Cordless Phones:
KX-TG8231/KX-TG8232
You must register this handset with your base unit before it can
be used. This installation manual describes only the steps
needed to register and begin using the handset. Please read
the base unit’s operating instructions for further details.
KX-TGA820
Charge the batteries for 7 hours before initial use.
Please read this Installation Manual before using the unit and
save it for future reference.
For assistance, visit our website:
http://www.panasonic.com/help for
customers in the U.S.A. or Puerto
Rico.
PQQX16156ZA DC0707YK0
TGA820(e).fm Page 2 Thursday, June 28, 2007 5:07 PM
Supplied accessories
Accessory item Order number Quantity
Charger PQLV30056Y 1
AC adaptor for charger PQLV209V 1
Rechargeable batteries
AAA (R03) size
Handset cover
Belt clip PQKE10481Z1 1
*1 The handset cover comes attached to the handset.
Note:
LPlease read the base unit’s operating instructions for additional/
replacement accessories.
*1
HHR-4DPA
(Part No. HHR-55AAABU)
PQYNTG8200ER 1
2
Sales and support information
LTo order additional/replacement accessories, call 1-800-332-5368.
LTTY users (hearing or speech impaired users) can call 1-866-605-
1277.
Connection
Hooks
(120 V AC,
60 Hz)
Note:
LUse only the supplied Panasonic AC adaptor PQLV209.
LThe AC adaptor must remain connected at all times. (It is normal for
the adaptor to feel warm during use.)
Fasten the AC adaptor cord to
prevent it from being disconnected.
2 For assistance, please visit http://www.panasonic.com/help
TGA820(e).fm Page 3 Thursday, June 28, 2007 5:07 PM
Battery installation/Battery charge
Important:
LUse only the supplied rechargeable batteries noted on page 2, 6.
LUSE ONLY rechargeable Ni-MH batteries AAA (R03) size.
LDo NOT use Alkaline/Manganese/Ni-Cd batteries.
LEnsure correct polarities (S, T) when installing the batteries.
LWipe the battery ends (S, T) with a dry cloth.
LWhen installing the batteries, avoid touching the battery ends (S, T)
or the unit contacts.
1 Press the notch on the handset cover firmly, and slide it in the
direction of the arrow.
2 Insert the batteries negative (T) end first. Close the handset cover.
3 Place the handset on the charger for 7 hours before initial use.
Note:
LIf you fully charged the batteries, but the operating time seems to be
short, wipe the battery ends (S, T) and the unit contacts with a dry
cloth.
For assistance, please visit http://www.panasonic.com/help 3
TGA820(e).fm Page 4 Thursday, June 28, 2007 5:07 PM
Attention:
A nickel metal hydride battery that is
recyclable powers the product you
have purchased.
Please call 1-800-8-BATTERY (1800-822-8837) for information on how
to recycle this battery.
Register the handset to the KX-TG8231/KX-TG8232
base unit
1
Lift the handset and press {OFF}. Place the handset on the base unit.
LContinue the operation even when the handset display shows
“Registering”.
2 Press and hold {x} (LOCATOR) on the base unit for about 5
seconds, until the registration tone sounds.
LIf all registered handsets start ringing, press {x} (LOCATOR) to
stop, then repeat this step.
3 With the handset still on the base unit, wait until a confirmation tone
sounds and w stops flashing.
Note:
LIf an error tone sounds, or if w is still flashing, register the handset
according to the base unit’s operating instructions.
Changing the display language
1
{MENU} (center of joystick)
2 Select M by pushing the joystick in any direction. i {SELECT}
3 Push the joystick up or down to select “Change language”. i
{SELECT}
4 Push the joystick up or down to select the desired language.
5 Press down the center of the joystick to save.
6 {OFF}
4 For assistance, please visit http://www.panasonic.com/help
TGA820(e).fm Page 5 Thursday, June 28, 2007 5:07 PM
Belt clip
You can hang the handset on your belt or pocket using the supplied belt
clip.
NTo attach the belt clip NTo remove the belt clip
For assistance, please visit http://www.panasonic.com/help 5
Loading...