Panasonic KX-TG2302B, KX-TG2302 User Manual

2.4GHz Digital Cordless Phone

Operating Instructions

Model No. KX-TG2302

Pulse-or-tone dialing capability

PLEASE READ BEFORE USE AND SAVE.

Charge the battery for 6 hours

1 Getting Started 2 Making/Answering Calls 3 Special Features 4 5 Guía rápida

Panasonic World Wide Web address: http://www.panasonic.com

for customers in the USA or Puerto Rico

before initial use.

Contents by Section

Things You Should Know

Attach your purchase receipt here.

For product service

• Visit our website: http://www.panasonic.com/support

• Contact us via the web at: http://www.panasonic.com/contactinfo

• Call us at: 1-800-211-PANA(7262) or 1-800-833-9626

When you ship the product

• Carefully pack your unit, preferably in the original carton.

• Attach a letter, detailing the symptom, to the outside of the carton.

Symptom

• Send the unit to an authorized servicenter, prepaid and adequately insured.

• Do not send your unit to the Panasonic Consumer Electronics

Company listed below or to executive or regional sales offices. These locations do not repair consumer products.

If you need assistance with the setup or operation, please call 1-800-211-PANA(7262) For hearing or speech impaired TTY users, TTY : 1-877-833-8855

Panasonic Consumer Electronics Company, Division of Matsushita Electric Corporation of America

One Panasonic Way, Secaucus, New Jersey 07094

Panasonic Sales Company, Division of Matsushita Electric of Puerto Rico, Inc.

Ave. 65 de Infantería, Km. 9.5, San Gabriel Industrial Park Carolina, Puerto Rico 00985

PQQX13980YA S1203-1014

AC Adaptor

Telephone Line

Cord

Power Outlet (AC 120 V, 60 Hz)

Single-Line Telephone Jack (RJ11C)

Hooks

Fasten the AC adaptor cord.

CHARGE Indicator (1-C)

[HANDSET LOCATOR] Button (3-A)

Charge Contacts (4-A)

IN USE Indicator (2-B, 3-A)

Antenna (4-F)

[SP-PHONE]

(Speakerphone) Button (2-A)

[ ] (TALK)

Button (2-A)

[REDIAL] Button (2-A)

[OFF] Button (2-A)

VOL. (VOLUME) Key ([

▼], [▲]) (2-A, 2-B)

[VOICE ENHANCER] Button and Indicator (1-C, 2-A)

TALK Indicator (2-A, 2-B)

Microphone (2-A)

Receiver RECHARGE

Indicator (4-A)

Headset Jack (4-D)

[FLASH/CALL WAIT]

Button (3-C, 3-D)

Antenna

Charge Contacts (4-A)

Speaker

Back side

[ ] (TONE) Button (3-B)

Getting Started Section 1

1-A Accessories 1-B Location of Controls

AC Adaptor ..................................one

Order No. PQLV1Z (PQLV1)

Telephone Line Cord ...................one

Order No. PQJA10075Z

Battery..........................................one

Order No. HHR-P104

Handset Cover .............................one

Order No. PQKK10140Z2

Belt Clip........................................one

Order No. PQKE10375Z2

Shoulder Rest Attachment ...........one

Order No. PQKE10364Z1

For extra orders, call 1-800-332-5368. For hearing or speech impaired TTY users, call 1-866-605-1277.

Handset Base unit

1-C Settings

Connect as shown.

•

USE ONLY WITH Panasonic AC ADAPTOR PQLV1 (Order No. PQLV1Z).

• The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.)

• The unit will not work during a power failure. We recommend connecting a standard telephone to the same telephone line or to the same telephone jack using the Panasonic KX-J66 T-adaptor.

To select the dialing mode TONE (preset) or PULSE

Make sure the handset and base unit are not being used. The handset must be operated near the base unit and while off the base unit.

1. Press [VOICE ENHANCER], then press [8].

• The VOICE ENHANCER indicator flashes.

2. To select PULSE, press [1]. OR To select TONE, press [2].

3. Press [VOICE ENHANCER].

• The handset beeps and the indicator light goes out.

For assistance, please call: 1-800-211-PANA(7262)

STOP

Insert the battery (#), and press it down until it snaps into the compartment ($).

Close the cover.

To replace the battery:

Press the notch on the cover firmly and slide it as indicated by the arrow. Replace the old battery with a new one (4-A). Close the cover and charge the battery for 6 hours.

Charge the battery for 6 hours.

• See section 4-A for more details.

• The unit beeps once and the CHARGE indicator lights.

CHARGE Indicator

Making/Answering Calls Section 2

2-A Making Calls 2-B Answering Calls

Press []then dial a phone number. OR

To have a hands-free phone conversation, press [SP-PHONE] and dial a phone number. When the other party answers, talk into the microphone.

• The TALK indicator lights.

• If an alarm tone sounds, see section 4-H.

To hang up, press [OFF] or place the handset on the base unit.

• The indicator light goes out.

• For the best operating performance, see section 4-F.

To redial the last number dialed

Press []or [SP-PHONE], then press [REDIAL].

To adjust the receiver/speaker volume during a conversation

There are 3 volume levels for the receiver and 6 volume levels for the speaker. To increase volume, press [▲]. To decrease volume, press [▼].

• If you try to increase/decrease volume when it is at the maximum/minimum level, the handset will beep 3 times.

Lighted handset keypad

The handset dialing buttons will light for a few seconds after pressing a button or lifting the handset off the base unit.

Voice Enhancer Technology

Panasonic’s Voice Enhancer Technology clarifies the voice of the person you are talking to, reproducing a more natural-sounding voice that is easier to hear and understand. Voice Enhancer Technology can be turned on or off. The factory preset is OFF.

•

Depending on the condition and quality of your telephone line, Voice Enhancer may emphasize existing line noise. If it becomes difficult to hear the caller, turn this feature off.

To turn this feature on, press [VOICE ENHANCER] during a conversation.

• The indicator lights in talk or speakerphone mode.

• The indicator light goes out after hanging up a call, but this

feature still remains on.

• To turn this feature off, press [VOICE ENHANCER] again. The indicator light goes out.

When a call is received, the handset rings, and the TALK indicator on the handset and the IN USE indicator on the base unit ﬂash rapidly.

If the handset is off the base unit, press []or [SP-PHONE].

• You can also answer a call by pressing any button except [▼], [▲] or [OFF].

If the handset is on the base unit, just lift up.

Selecting the ringer volume

Make sure the handset and base unit are not being used. The handset must be operated near the base unit and while off the base unit.

• To select high (preset), medium, or low,

press [▼] or [▲] to select volume. The volume will change and ring. To stop ringing, press [OFF] or [VOICE ENHANCER].

• To turn the ringer off, press and hold [▼] until 2 beeps sound.

• To turn the ringer on, press [▼] or [▲].

The handset will ring at the low level.

• You can adjust the ringer volume while a call is ringing. Press [▼] or [▲] while the handset is ringing. To turn the ringer off, press and hold [▼] until 2 beeps sound.

Temporary ringer off

While the handset is ringing for an outside call, you can turn the ringer off temporarily by pressing [OFF]. The handset will ring again as normal the next time a call is received.

Selecting the ringer tone

Make sure the unit is not being used and the handset is lifted off the base unit. 7 ringer tones are available (3 bell ringer patterns and 4 melody patterns).

• If you subscribe to a Distinctive Ring Service (such as IDENTARING) from your telephone company with 2 or 3 consecutive rings, select a bell ringer pattern (1 to 3). If you select a melody pattern, you will not be able to distinguish lines by their ringers.

• If you select one of the melody ringer patterns, the ringer will continue to sound for several seconds if:

— the caller hangs up before you answer the call, or — another person answers the call using another phone

connected on the same line.

Press [▼] or [▲], then select the desired ringer tone by pressing

[1] (preset) to [7].

[1] to [3]: Bell ringer patterns [4] to [7]: Melody patterns

• After pressing [▼] or [▲], the handset will ring using the current ringer tone.

• The handset will ring and the ringer tone will change.

• To stop ringing, press [OFF] or [VOICE ENHANCER].

For assistance, please call: 1-800-211-PANA(7262)

+ 5 hidden pages