TG1100_1102CX(e-e).book Page 1 Tuesday, August 29, 2006 10:30 AM
Operating Instructions
Digital Cordless Phone
KX-TG1100
Charge the batteries for about
7 hours before initial use.
Model No.
KX-TG1100CX
KX-TG1102CX
Table of Contents
Introduction ............................................................ 2
Preparation ............................................................. 4
Making/Answering Calls ........................................ 9
Phonebook............................................................ 11
Useful Telephone Settings .................................. 12
Caller ID Service ................................................... 15
Multi-unit Operation ............................................. 16
Useful Information................................................ 17
You must subscribe to Caller ID service to use this
feature.
Caller ID
Please read these operating instructions before using the unit and save them for future
reference.
TG1100_1102CX(e-e).book Page 2 Tuesday, August 29, 2006 10:30 AM
Introduction
Introduction
Thank you for purchasing a new Panasonic digital cordless phone.
For your future reference
Attach or keep original receipt to assist with any repair under warranty.
Serial No. (found on the bottom of the unit)
Date of purchase
Name and address of dealer
Note:
L In the event of problems, you should contact your equipment supplier in the first instance.
Your phone
KX-TG1100 KX-TG1102
Note:
L The handsets have been pre-registered for use with their base unit. If not registered, see
page 17.
2
TG1100_1102CX(e-e).book Page 3 Tuesday, August 29, 2006 10:30 AM
Included accessories
Introduction
No. Accessory items
1 AC adaptor for base unit
Quantity
KX-TG1100 KX-TG1102
11
Part No. PQLV19BX
2 Telephone line cord 1 1
3 Rechargeable batteries AAA (R03) size
24
Part No. HHR-55AAAB or HHR-4EPT
4 Handset cover
5 Charger
*1
12
–1
Part No. PQLV30018
6 AC adaptor for charger
*2
–1
Part No. PQLV200BX
*1 The handset cover comes attached to the handset.
*2 The AC adaptor for the charger comes connected with the charger.
123
456
Note:
L When replacing the batteries, use only 2 rechargeable AAA (R03) size nickel metal hydride
(Ni-MH) batteries. We recommend using Panasonic rechargeable batteries (Model No.
HHR-4EPT).
L We cannot be responsible for any damage to the unit or degradation of performance which
may occur from using non-Panasonic rechargeable batteries.
3
TG1100_1102CX(e-e).book Page 4 Tuesday, August 29, 2006 10:30 AM
Preparation
Preparation
Important information
General
L Use only the AC adaptor included with this
product, noted on page 3.
L Do not connect the AC adaptor to any AC
outlet other than a standard 220–240 V
AC outlet.
L This product is unable to make calls when:
− The portable handset battery(ies) need
recharging or have failed.
− There is a power failure.
− The key lock feature is turned on.
− The call bar feature is turned on (only
phone numbers stored in the unit as
emergency numbers can be called).
L Do not open the base unit or handset
other than to replace the battery(ies).
L This product should not be used near
emergency/intensive care medical
equipment and should not be used by
people with pacemakers.
L Care should be taken that objects do not
fall onto, and liquids are not spilled into,
the unit. Do not subject this product to
excessive smoke, dust, mechanical
vibration or shock.
L Only the included handset can be used
with the base unit. No other handsets can
be registered or used.
Environment
L Do not use this product near water.
L This product should be kept away from
heat sources such as radiators, cookers,
etc. It should also not be placed in rooms
where the temperature is less than 5 °C or
greater than 40 °C.
L The AC adaptor is used as the main
disconnect device. Ensure that the AC
outlet is installed near the unit and is
easily accessible.
Warning:
L To prevent the risk of electrical shock, do
L Unplug this unit from power outlets if it
Battery caution
L We recommend using the battery(ies)
L Do not mix old and new batteries.
L Do not dispose of the battery(ies) in a fire,
L Do not open or mutilate the battery(ies).
L Exercise care when handling the
L Charge the battery(ies) in accordance
L Only use the included base unit (or
not expose this product to rain or any
other type of moisture.
emits smoke, an abnormal smell or makes
unusual noise. These conditions can
cause fire or electric shock. Confirm that
smoke has stopped and contact an
authorised service centre.
noted on page 3. Use only rechargeable
battery(ies).
as they may explode. Check local waste
management codes for special disposal
instructions.
Released electrolyte from the battery(ies)
is corrosive and may cause burns or injury
to the eyes or skin. The electrolyte may be
toxic if swallowed.
battery(ies). Do not allow conductive
materials such as rings, bracelets or keys
to touch the battery(ies), otherwise a short
circuit may cause the battery(ies) and/or
the conductive material to overheat and
cause burns.
with the information provided in these
operating instructions.
charger) to charge the battery(ies). Do not
tamper with the base unit (or charger).
Failure to follow these instructions may
cause the battery(ies) to swell or explode.
4
TG1100_1102CX(e-e).book Page 5 Tuesday, August 29, 2006 10:30 AM
Preparation
Connections
Base unit
Hooks
LINE
To telephone
network
(220–240 V,
50/60 Hz)
Use only the included AC adaptor
and telephone line cord.
Charger (KX-TG1102 only)
(220–240 V,
50/60 Hz)
Location
For maximum distance and noise-free
operation, place your base unit:
− Away from electrical appliances such as
TVs, radios, personal computers or other
phones.
− In a convenient, high and central location.
If you subscribe to a DSL service
L Please attach a noise filter (contact your
DSL service provider) to the telephone
line between the base unit and the
telephone line jack in the event of the
following:
– Noise is heard during conversations.
– Caller ID features (page 15) do not
function properly.
Hooks
To single-line
telephone jack
Use only the included AC adaptor.
Note:
L Never install telephone wiring during a
lightning storm.
L Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight
of the adaptor may cause it to become
disconnected.
L The unit will not work during a power
failure. We recommend connecting a
standard telephone to the same
telephone line or to the same telephone
jack using a T-adaptor.
Telephone
line cord
Noise filter
(For DSL users)
Battery installation
Insert the batteries negative (T) terminal
first. Close the handset cover.
Note:
L Use only the included rechargeable
batteries (page 3, 4).
5
TG1100_1102CX(e-e).book Page 6 Tuesday, August 29, 2006 10:30 AM
Preparation
Turning the power on/off
L The battery strength may not be displayed
Power on
Press {ih} for about 1 second.
Power off
Press {ih} for about 2 seconds.
Controls
charger without any ill effect on the
batteries.
correctly after you replace the batteries. In
this case, place the handset on the base
unit or charger and charge for at least 7
hours.
Battery charge
Place the handset on the base unit or
charger for about 7 hours before initial
use.
Battery strength
Battery icon Battery strength
054 Fully charged.
5 High
6 Medium
7 Low
074 Needs to be charged.
Panasonic Ni-MH battery performance
Operation Operating time
In continuous use 10 hours max.
In continuous standby
mode
Note:
L It is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
L Actual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
L Even after the handset is fully charged,
the handset can be left on the base unit or
120 hours max.
Handset
A
B
C
D
E
F
G
H
I
1
2
4
5
7
8
0
R
N
J
K
C
L
3
6
9
M
H
INT
A Receiver
B Display
C {k} (Phonebook)
D {C} (Talk)
E Navigator ({e}/{v}/{>}/{<})
F {R} (Redial/Pause)
G {R} (Flash)
H Charge contacts
I Microphone
J {j/OK} (Menu/OK)
K {ih} (Off/Power)
L {C} (Clear)
M {INT} (Intercom)
N Ringer
6