Panasonic EY0214B User Manual

PanasoniCx

Operating Instructions

Panasonic

Battery charger

Model No: EY0214

nnnnflflflM-

^—crz=^

Before operating this unit, please read these instructions completely and save this manual for future use.

SAVE THESE INSTRUCTIONS

MP ORT ANT SA FETY NST RUC nO NS

>: >AV E T HES E

TRU CTI ON S r. .

manual contains important safety and
operating Instructions for battery
charger EYQ214.

2) Before using battery charger, read ail
instructions and cautionary markings
on (1) battery charger. (2) battery
pack.

3) CAUTION -To reduce the nsk

of injury, charge only Battery Pack as
shown below.
EY9103, EY9101, EY9001. EY9006,
EY9180, EY9080, EY9182, EY9086,
EY9065, EY9106, EY9107, EY9136,
EY9117, EY9230, EY9200. EY9108.
EY9210
Other types of batteries may burst
causing personal injury and damage.

4) Do not expose charger to rain or

snow.

5} To reduce risk of damaging the electric

plug and cord, puM by plug rather than
cord when disconnecting charger.

c. that wire size is large enough for

ampere rating of charger as specified
below.

RECOMMENDED MINIMUM AWG SIZE OT

EXTENSION CORDS FOR

BATTERY CHARGERS

AC Input Rating. Ampefas
Equal to or

graatar than

0

8) Do not operate charger with

damaged cord or plug—replace them

imfTtediately.

9) Do not operate charger If it has
received a sharp blow, been

dropped, or otherwise damaged in

any way; take it to a qualified

serviceman.

10) Do not disassemble charger; take it
to a qualified serviceman when
service or r^air is required. Incorrect
reassembly may result In a risk of
electric ^ock or fire.

11) To reduce the risk of electric shock,
unplug charger from outlet before
attempting any maintenance or
cfeartirig.

12) The charger and battery pack are
specifically designed to work
together. Do not attempt to charge
any other cordless tool or battery
pack with this charger.

But less
than 25 50 too 150

2 18 16 18 16

AWG Size of Cord

Length of Cord, Feet

6) Make sure cord is located so that it will
not be stepped on, tripped over, or
otherwise subjected to damage or
stress.

7) An extension cord should not be
used unless absolutely necessary.
Use of Improper extension cord could
result in a risk of fire and electric

shock. If extension cord must be
used, make sure;
a. that pins on plug of exteneon cord

are the same number, size and
shape as those of plug on charger.

b. that extension cord Is properly

wired and in good electrical
condition.

-1 -

13) Do not attempt to charge the battery

pack with any other charger.

14) Do not attempt to disassemble the

battery pack housing.

15) Do not store the tool and battery
pack in locations where the

temperature may reach or exceed

122°F (50**C) (such as a metal tool

shed, or a car in the summer), which
can lead to deterioration of the
storage battery.

16) Do not charge battery padc when the

temperature is BELOW 32‘F (0”C) or
ABOVE 104*F (40"C). This is very
irr^Kxrtant.