Panasonic ES-8044, ES8048, ES-8042, ES-8043 User Manual

IN USA CONTACT: Division of Panasonic Corporation of North America Panasonic Consumer Electronics Company
One Panasonic Way 2F-3 Secaucus, NJ 07094
IN PUERTO RICO CONTACT: Panasonic Sales Company Division of Panasonic Corporation of Puerto Rico, Inc.
San Gabriel Industrial Park 65 Carolina, Puerto Rico 00630
IN CANADA CONTACT: AU CANADA, CONTACTER: Panasonic Canada Inc.
5770 Ambler Drive, Mississauga, Ontario L4W 2T3 (905) 624-5010 Vancouver: (604) 278-4211 Calgary: (403) 295-3955 Toronto: (905) 624-8447 Montréal: (514) 633-8684
En México: Panasonic de México, S.A de C.V. México D.F.
Amores 1120, Col. del Valle, 03100 Tel: 54 88 10 00
Service Assistance Accessories Dépannage
Assistance Accessoires
Infantry Avenue KM9.5
R
Wet/Dry Rechargeable Shaver
Resoir Rechargeable (à sec/avec mousse)
Rasuradora Recargable Agua/Seco
Operating Instructions
Manuel d’utilisation
Instrucciones de operación
Model No. ES8048/ES8044/ES8043/ES8042 N° de modèles ES8048/ES8044/ES8043/ES8042 Modelo No. ES8048/ES8044/ES8043/ES8042
Call 1-800-338-0552 (In USA) panasonic.com/shavers (In USA) Call 1-800-467-3405 (In Canada, only for shavers) Composer 1-800-467-3405 (Au Canada, pour les rasoirs seulement)
No.1 EN FR ES (U.S.A./CANADA)
Printed in Japan
Imprimé au Japon
B
Before operating this unit, please read these instructions completely.
B
Il est recommandé de lire attentivement ce manuel avant dutiliser lappareil.
B
Antes de operar este producto, lea este instructivo en su totalidad.
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appli­ance, basic precautions should always be followed,
including the following: Read all instructions before using this appliance.
DANGER
1. Do not reach for the appli­ance if it has fallen into water. Unplug immediately.
2. Do not place or store the power cord where it can fall into a tub or sink. Do not place or drop it into water or other liquid. Before charging the shaver,
3. wipe off any moisture from the shaver and power cord. Always handle with dry hands.
WARNING
1.
Do not use this shaver with damaged shaving blades and/or foil, as facial injury may occur.
2.
Close supervision is necessary when this shaver is used by, on or near children or invalids.
3. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommend­ed by the manufacturer.
4. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or dam­aged or dropped into water.
To reduce the risk of electric shock:
To reduce the risk of burns, fire, electric shock, or injury to persons:
4. Always charge the shaver in a cool, dry place.
5. Except when charging, always unplug the power cord from the electrical out­let.
6. Unplug this appliance before cleaning. Charger unit is not for immer-
7. sion or for use in shower.
8. Do not use an extension cord with this appliance.
Return the appliance to a ser­vice center for examination and repair.
5. Never drop or insert any object into any opening.
6. Keep the cord away from heated surfaces.
7. Do not use outdoors or oper­ate where aerosol (spray) products are being used or where oxygen is being admin­istered.
8. Always attach plug to appli­ance first, then to outlet. To disconnect, turn off the switch, then remove plug from outlet.
Index Indice
ENGLISH Page 7 FRANÇAIS Page 13 ESPAÑOL Página 20
SAVE THESE INSTRUCTIONS
32
charge
status
recharge
charge
status
[ES8043]
P
R
Q
K
[ES8042]
A
B
N O
E
C D
F
G
H
L
M
[ES8044]
[ES8048]
II
J
b
I
c
I
a
1
2
[ES8048] [ES8044]
5
(a)
(b)
8
(A) (B)
(A) (B)
high
charge
status
high
charge
status
mid low
6
high
mid low
charge
status
[ES8043]
(C) (D)
recharge
mid low
charge
status
3
4
[ES8042]
(E)
charge
status
recharge
charge
status
7
[ES8048] [ES8044]
[ES8043]
[ES8042]
high
recharge
mid
low charge status
charge status
charge status
9
54
7
Before use
This Wet/Dry shaver can be used for wet shaving with shaving lather or for dry shaving. You can use this water­tight shaver in the shower and clean it in water. The following is the sym­bol of Wet shaver. The symbol means that hand-held part may be used in a bath or shower.
Treat yourself to wet lather shaves for at least three weeks and notice the difference. Your Panasonic Wet/ Dry shaver requires a little time to get used to because your skin and beard need about a month to adjust to any new shaving method.
Parts identification
(see fig. 1)
A Protective cap B System outer foil C System outer foil release but-
tons
D Foil frame E Inner blades F Foil frame release buttons G Pivot action selector H LED display I Battery capacity monitor
I-a high I-b mid I-c low
J Charge status lamp K Low battery indicator L On/Off switch M Finger rest N Trimmer O Trimmer handle P Adaptor Q Power cord R Charging stand
READ ALL INSTRUCTIONS BE­FORE USE.
Charging
Connect the power cord to the shaver, and plug the adaptor into an AC outlet. (see fig. 1 (A)) The shaver will adjust automatically to voltages between 100-240V AC. In some areas, a special plug adap­tor may be required.
When charging the shaver for the first time or when it has not been in use for more than 6 months, the charge status lamp may not illumi­nate for a few minutes after opera­tion. It will eventually illuminate if kept connected.
Adequate ambient temperature for charging is between 15 °C (59 °F) to 35 °C (95 °F).
If it is far below or over the appro­priate temperature, the charging time may be longer, or the adaptor may not function.
In particular, low temperature may shorten the life span of the re­chargeable battery. In this case, the
10
d
e
f
c
b
a
g
6 7
9
If you push and hold the On/Off switch for more than 2 seconds, it will activate the turbo mode for sonic vibration cleaning. (see Cleaning your shaver”) Caution: Shaving with “sonic” vibration may damage your skin. Please turn it off and on again to deactivate the turbo mode.
Do not place fingers on the On/Off switch during use. This may cause the shaver to stop during use or change to the sonic vibration cleaning mode. Place your finger on the finger rest dur­ing use.
Hold the shaver at a right angle (90°) to your skin (see fig. 3). Start out shaving by applying gentle pressure to your face. Stretch your skin with your free hand and move the shaver back and forth in the direction of your beard. You may gently increase the amount of pressure as your skin be­comes accustomed to this shaver. Applying excessive pressure does not provide a closer shave.
Pivot action selector
(see fig. 4) Use the pivot action selector to choose the shaving mode, “soft” and lock based on your shaving prefer­ence. The pivot action can be changed whether the switch is turned on or off.
System outer foil
(see fig. 5) System outer foil has a slit blade (a) between 2 foils (b). They move up and down independently to follow the contours of your face. The slit blade catches and cuts longer and lying hairs easily.
For wet shaving
Put a thin layer of shaving foam on your face which works as a lubrica­tor. Shaving foam is the most suit­able among many other shaving aids (gel, soap, cream, etc.). Do not put a thick layer of shaving foam as it may affect shaver’s performance. If the shaving head is clogged with foam, simply rinse it under running water.
Using the trimmer
(see fig. 6) Slide the trimmer handle up to open the trimmer. Place the trimmer at a right angle to your skin and move it downward to trim sideburns.
Cleaning your shaver
(see fig. 7)
Warning – To prevent electric shock or personal injury, discon­nect the power cord from the shaver before cleaning with water.
For cleanliness and convenience, we recommend that you clean your shaver with water and a liquid hand soap. Regular cleaning will keep your shaver in good condition while pre­venting odors or bacteria from devel-
8
charge status lamp blinks twice per second.
[for ES8048, ES8044] The charge status lamp will glow when the shaver is being charged. The battery capacity monitor will fully illuminate and the charge status lamp will blink after charging is completed (see fig. 2 (A)). 10 minutes after charging is com­pleted, the battery capacity monitor will turn off and the charge status lamp will continue to blink (see fig. 2 (B)). You can fully charge the shaver in 1 hour if the LED display shows “low”. The battery capacity monitor indi­cates the charge remaining in the battery in 3 levels (high/mid/low). The unit can be used once or twice more after low” starts to blink (Differs de- pending on usage.).
[for ES8043] The charge status lamp will glow when the shaver is being charged. It will blink when charging is com­pleted (see fig. 2 (D)). You can fully charge the shaver in 1 hour if the low battery indicator blinks (see fig. 2 (C)). The unit can be used once or twice more after the low battery indicator starts to blink.
[for ES8042] The charge status lamp will glow when the shaver is being charged. It will blink when charging is completed (see fig. 2 (E)).
A full charge will supply enough power for approx. 14 shaves (3 min­utes per shave for a normal beard). Before travelling, charge your shaver fully for 1 hour if you will not be tak­ing the adaptor with you. In case your shaver is without charge, you may quick charge it for 1 shave in about 5 minutes.
Charge with charging stand
(see fig. 1 (B)) To charge with the charging stand, connect the power cord to the charg­ing stand. Place the shaver into the stand, and plug the adaptor into the AC outlet. You can always store your shaver in the charging stand to maintain full battery capacity. This shaver cannot be overcharged.
Using your shaver
Caution – The system outer foil is very thin and can be damaged if handled improperly. Before each use, always check the foil for dam­age. To avoid personal injury, do not use if the foil or other parts of the shaving head is damaged.
Disconnect the power cord from the shaver, and push the On/Off switch to turn the shaver on.
98
Loading...
+ 9 hidden pages