English 2
Deutsch 7
Français 12
Italiano 17
Español 22
Nederlands 27
Português 32
Norsk 37
Svenska 42
Dansk 47
Suomi 52
Before operating this unit, please read these instructions completely and
save them for future use.
Polski 57
Česky62
Slovensky67
Română72
Magyar77
Türkçe 83
Русский88
Українська94
繁體中文 100
ไทย106
Before use
1Caution for charging
English
•
Keep the charger away from water.
•
Do not use with wet hands.
•
Do not charge the appliance if you have damaged it by dropping it.
•
Charge the appliance at temper
•
Do not charge when exposed to direct sunlight or heat.
•
Use only the included charger.
•
Disconnect the charger by grasping the plug of the charger, when not in
use or before cleaning.
•
Do not cut, damage or modify the cord. Do not pull, twist, or bend the cord
with unnecessary force.
•
Do not place heavy objects on the cord or allow the cord to get pinched in
between objects. Do not wind the cord around the appliance.
•
The supply cord of this appliance cannot be replaced; if the cord is
damaged, the charger should be replaced.
•
Do not use an extension cord to connect the charger to a household outlet.
1Caution for using
•
Do not use the appliance near substances such as benzine, thinner,
sprays, etc.
•
Do not use the appliance with a damaged or broken cup.
•
Take care to use the appliance only on your nose.
•
Do not focus the appliance on any one spot on your skin.
•
Do not use the appliance on pimples, blemishes, sunburned or broken
skin, etc.
•
Do not pass the appliance over the same point more than 3 times if you
have sensitive skin.
•
Use the appliance only for its intended use as described in this manual.
1Caution for cleaning and storage
•
Do not use benzine, thinner or any other solvents to clean the appliance.
•
Do not leave the appliance submerged in water for a long period of time.
•
Rinse the appliance in tap water; do not use detergent or hot water.
•
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
•
Do not disassemble or modify the appliance. Do not attempt repairs by
yourself.
- Repairs must always be conducted through your dealer.
Safety instructions
atures between 0
°C and 40 °C.
2
Parts identification
(A)
(B)
(D)
(C)
(E)
(F)
(G)
(H)
(I)
(K)
(J)
(A) Cover
(B) Mist Nozzle
(C) Suction Cup
(D) Suction Hole (Filter)
(E) Charge Indicator Light
(F) Water Tank
(G) Water Inlet Cap
(H) Water Outlet
(I) Power Switch (1/0•charge)
(J) Cleaning Tool
(K) Charger
English
Charging
Charging your pore cleanser
1. Connect the charger to a household outlet and place it
on a flat surface.
2. Switch the appliance off and insert it into the charger as
illustrated.
The charge indicator light glo
removed from the charger.
The charging time is 12 hours
•
A full charge will provide approximately 20 minutes of
•
usage.
ws until the appliance is
.
3
Using
•
We recommend you use it when your pores are enlarged such as after
English
taking a bath, etc.
Cleansing two or three times a week is recommended.
•
1. Remo
ve an
Never use the appliance on skin coated with cleansing lotion or facial
•
soap.
2. Remove the cap and pour tap water into the water tank.
3. Slide the power switch to “1”.
The mist nozzle will produce a fine spray of water.•
4. Move the appliance slowly around the tip of
your nose.
Roughly cleanse the entire surface of your
•
nose without focusing on any one spot.
If you apply the nozzle directly on to your
•
skin to improve adhesion, the mist will
automatically stop.
5. Mo
ve the appliance over your nose in the
direction of the arrows.
6. Rinse your face, and keep your face sufficiently moisturized using
moisturizing lotion or any other skin conditioner you normally use.
Using your pore cleanser
y make-up from your face, leaving your skin bare.
Around the tip and wings of nose
1. Move the appliance all over your nose for 1 minute.
2. Move it over the wings of your nostrils for 2 minutes.
(Do not repeatedly move it over the wings of your nostrils where the skin is
sensitive.)
When mist is not released
1. Turn the power switch off and remove the cap, then
insert the pointed end of the cleaning tool or a
cotton swab into the mist nozzle a few times.
2. Pour tap water into the water tank.
3. Turn the power switch on and block the mist nozzle for approximately
10 seconds (while checking to see if the water in the tank is bubbling).
4. Drain the water out of the water tank.
4
If the mist is still not released after repeating the steps above, take the
•
appliance to your dealer.
Water droplets may sometimes be found on the appliance. This is normal.
•
This is the water that has remained after inspection and is sanitary.
Cleaning
Cleaning your pore cleanser
After using the appliance
The appliance can be washed using just water.
1. Pour water (warm if you like) into a washbowl.
Do not use hot water or detergent.
•
2. Remove the suction cup
the water, and turn the power switch on to wash for
approximately 15 seconds.
3. Remove the appliance from the water. Then, leaving
the appliance switched on for approximately
30 seconds
the water off.
4. Empty the water tank and allow it to dr
cap off.
5. Wipe the body of the appliance and the suction cup
with tissues or cotton swabs, taking particular care to
thoroughly wipe the insides of the suction cup.
to allow water to drain from the body, shake
, soak the suction hole (filter) in
y by leaving the
Regular maintenance
1Suction hole (filter)
Turn the power switch off, soak the suction hole (filter) in
the water (warm if you like), and then remove any
accumulated dirt using the cleaning brush provided.
Do not use the needle side of the brush for cleaning.
•
Do not use hot w
•
1Mist nozzle
Turn the power switch off and remove any dirt using
the supplied cleaning tool.
ater (70
°C or higher) or detergent.
English
5
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.