Panasonic EH-2424 Operating Instructions
Before operating this unit, please read these instructions completely and save this manual for future use.
In particular, please carefully read the safety precautions before use to ensure proper operation.
Facial Ionic Steamer
Operating Instructions
Model No. EH2424
test
0/1
No.1 EN, KO, TW, TH, AR（第三地域）
No.1 EN, GR, FR, IT, NE, SP, DN, PO, NR, SW, FN, Tu, Po, Cz, Hu, Ru, Russi, Uk
Printed in China
Matsushita Electric Works, Ltd.
1048, Kadoma, Osaka 571-8686, Japan
EH2424欧州05.7.27 11:52AM ページ1
32
4
5
6 7
8
test
0/1
INDEX
ENGLISH ............................. Page 4
DEUTSCH ........................... Seite 9
FRANÇAIS ........................... page 13
ITALIANO ......................... Pagina 17
1
2 3
A
B
D
C
test
0/1
0/1
test
fu
ll
e
m
p
ty
0/1
q
o
!6
!1
u
i
e
w
y
r
t
!0
!2
!3
!4
!5
EH2424欧州05.7.27 11:52AM ページ2
5
30 seconds.
- It is normal for hot water droplets to
be discharged at the begining of the
steam flow.
-A whizzing may be heard. This is the
sound of electric discharge which is
normal.
• Do not operate the appliance with the
water supply cup placed on the nozzle.
2. Adjust the angle (up/down) of the
nozzle. (Fig. 4)
• Adjust the nozzle while taking care not
to directly touch the steam.
How to use the steam
I Move your face slightly to the left and
right so that the steam spreads evenly.
I Using the steam on your nose is
effective on the T-zone.
1. Keep your face at least 25 cm away
from the steam outlet, using the supplied
25-cm measure as a guide. (Fig. 5)
2. Position the steam outlet towards your
face slightly above your chin. (Fig. 6)
3. After use, wipe off the water (such as
with a tissue), then also apply a lotion to
prepare your face and apply an
emulsion to supplement skin oil.
Examples of the uses of
the facial ionic steamer
In addition to using the appliance on bare
skin, it can also be used in combination
with facial treatments.
I Before cleansing
1. Use the appliance for about 3 minutes.
(This lifts dirt from the skin.)
2. Perform cleansing.
I Apply massaging cream and use the
steam while massaging your skin.
I Use the appliance after applying lotions
and face liquids.
After use
(Be sure to discard the water in the tank
every time after use.)
1. Press the power switch until a click is
heard to turn off the power and then
remove the plug from the power outlet.
• The lamp turns off.
• Be careful not to touch the steam when
pressing the switch.
• Do not operate the appliance if it
contains no water.
- Doing so will quicken the
accumulation of water scale, which
may result in poor steam discharge.
2. Leave the appliance alone to cool for at
least 10 minutes.
3. Discard the water in the drain cup.
4. Pour out the water from the appliance in
the direction of the arrow as shown.
• Emptying the water in a direction other
than that indicated by the arrow may
get the switch wet, which may cause a
malfunction.
• To prevent risk of burns or scalding
when discarding the water, hold the
bottom of the appliance. (Fig. 7)
Note: When discarding the water, be
careful not to get water on the
power plug and cord.
5. Wipe off any water from the appliance.
• Do not wind the cord around the
appliance.
• If the water supply cup is to be placed
upside down on the appliance for
storage, first wipe off any water from
the cup.
Cleaning
Do not wash or soak the appliance in
water.
Cleaning around the water inlet and
water level. (Clean once a month)
I To remove and prevent water scale
deposits, let the appliance cool for at
least 10 minutes after use and then
clean according to the following steps.
After the operation in step 4 on “After
use” of the Instruction Manual, replace
4
Parts identification (Fig. 1)
D
A
q Nozzle
w Steam outlet
Nano-sized ion steam is discharged.
e Power switch
r Test switch
The test switch is used to check the
ionization (atomization) of the
steam. The ionize lamp turns off
and non-ionized steam is discharged
only while the test switch is pressed.
t Ionize lamp
The lamp turns on when the power
is turned on. The lamp turns off
while the test switch is pressed.
y Cord
u Main panel
i Cosmetic ring
DB
o Water inlet gasket
!0 Water inlet
DC
!1 Water supply cover
!2 Water supply cover open button
!3 Handle
!4 Water level
When water is filled to the “full”
mark, the appliance can be used for
approximately 12 minutes.
!5 Drain cup
Water collects in the drain cup if too
much water is added.
DD
!6 Water supply cup
When water is filled to the “full” mark
(top level inside the cup), the
appliance can be used for
approximately 12 minutes.
Before use
1. Excessive use is detrimental to the skin.
• It is recommended that you start by
using the appliance two to three times
a week.
Thereafter, adjust the frequency and
duration of use while observing the
condition of your skin.
If any skin trouble develops, stop use
immediately.
• Recommended usage is once a day.
2. Your skin condition also may differ
according to your health.
• Use the appliance while observing the
condition of your skin.
3. If you feel any skin discomfort, such as
rash, redness, itching, and so forth, stop
use and consult a physician.
4. Skin problems may be caused by stress,
health, organic disorder or cosmetics.
In such instances, consult a specialist.
Preparation
1. Check that the drain cup is installed in
the appliance.
2. Press the water supply cover open
button to lift up the water supply cover.
(Fig. 2)
3. Use the water supply cup to fill the
appliance with water.
• Use distilled water or water that has
been softened by a water softener.
The water softener is separately
available.
(Fig. 3)
When using the separately available
water softener, read the supplied
operating instructions before use.
If hard water is used, the mineral
content of the water will form deposits
on the inside of the boiler of the
appliance and may obstruct the flow of
steam.
• Be careful not to let water come in
contact with the nozzle, cosmetic ring,
main panel, and switch.
• Dispose any leftover water in the water
supply cup.
• Do not add water past the full mark on
the water supply cup or if water
remains in the appliance. (Check the
water level and add water only when
there is no remaining water in the
appliance.)
4. Close the water supply cover.
Using the facial ionic steamer
1. Insert the plug into a power outlet and
press the power switch until a click is
heard.
• Ionize lamp turns on.
• Ionized steam is released after about
EH2424欧州05.7.27 11:52AM ページ4
Loading...