This service information is designed for experienced repair technicians only and is not intended for use by the general public.
It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.
Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service
or repair the product or products dealt within this service information by anyone else could result in serious injury or death.
1. Panasonic Document Imaging Company and other Panasonic Sales Companies
reserve the right to change any information enclosed herein without prior notification.
(This includes, but is not limited to, parts pricing, availability, and text)
2. Electrical parts supplied may include previously used components.
3. Important Safety Notice
Components identified by a mark, have special characteristics important for safety.
When replacing any of these components, use only manufacturer’s specified parts.
4. In New Parts column, "N" indicates part is used only in DX-600/800 models,
"C" indicates part is used in previous models.
5. In Remarks column, "PM" indicates “Periodic Maintenance Part".
6. This “Unit" which includes other itemized parts is provided as
“Limited Availability" for your convenience, and will only be offered for up to 3 years
after the production of the unit ceases. However, the individual contents of
the assembly will be available for the standard period.
7. This Product Uses Lead (Pb) Free Solder Printed Circuit Boards (PCBs).
Information regarding Lead-Free (PbF) solder;
Distinction of PbF PCB:
PCBs (manufactured) using lead free solder will have a mark following
the PCB part numbers in a label on the PCB.
Caution:
Pb free solder has a higher melting point than standard solder; typically
the melting point is 50 - 70 F (30 - 40 C) higher. Please use a soldering iron
with temperature control and adjust it to 700 20 F (370 10 C). Exercise care
while using higher temperature soldering irons, do not heat the PCB for too long
to prevent solder splash or damage to the PCB.
Pb free solder will tend to splash when heated too high (about 1100 F/600 C).
ECO SOLDER M705 (available from Senju Metal Industry Co., Ltd.;
URL: http://www.senju-m.co.jp) is recommended when repairing PbF PCBs.
The contents of this Parts Manual are subject to change without notice.
Published in Japan.
2
General Annotations
8. Important Notice
(especially for countries belonging to the European Union):
Some of the new parts introduced by this document are the parts which now comply
with the national laws transposed from the EU Directive on the restriction of the use of
certain hazardous substances (RoHS) in electrical and electronic equipment, effective
July 1, 2006 in the EU countries.
In order for the product to comply with the RoHS Directive, the six particular substances
(lead, mercury, cadmium, hexavalent chromium, polybrominated biphenyls, and
polybrominated diphenyl ethers) have been either totally eliminated or limited to the
concentration level below maximum allowed. Consequently spare parts have been
changed to RoHS-compliant parts where applicable.
To ensure compliance with the spare parts application of the RoHS legislation, please
make sure to follow the details provided in this manual when ordering spare parts and
carrying out repairs.
The contents of this Parts Manual are subject to change without notice.
Published in Japan.