Panasonic DMC-FT2 Basic Operation Guide

Basic Operating Instructions

Digital Camera

Model No. DMC-FT2

Before use, please read these instructions completely.

Please also refer to Operating Instructions (PDF format) recorded on the CD-ROM containing the Operating Instructions (supplied).

You can learn about advanced operation methods and check the Troubleshooting.

VQT2M46

Please be sure to read “(Important) About the waterproof/dustproof and anti-shock performance of the camera waterproof performance the unit from being mishandled, which may cause water to seep in.

Dear Customer,

We would like to take this opportunity to thank you for purchasing this Panasonic Digital Camera. Please read these Operating Instructions carefully and keep them handy for future reference. Please note that the actual controls and components, menu items, etc. of your Digital Camera may look somewhat different from those shown in the illustrations in these Operating Instructions.

Carefully observe copyright laws.

• Recording of pre-recorded tapes or discs or other published or broadcast material for purposes other than your own private use may infringe copyright laws. Even for the purpose of private use, recording of certain material may be restricted.

” (P8) before using this unit underwater to prevent

” (P6) and “Maintenance and

Information for Your Safety

WARNING:

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PRODUCT DAMAGE,

• DO NOT EXPOSE THIS APPARATUS TO RAIN, MOISTURE, DRIPPING OR SPLASHING AND THAT NO OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHALL BE PLACED ON THE APPARATUS.

• USE ONLY THE RECOMMENDED ACCESSORIES.

• DO NOT REMOVE THE COVER (OR BACK); THERE ARE NO USER

SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

IF THE POWER CORD OF THIS EQUIPMENT IS DAMAGED, IT MUST BE REPLACED WITH AN ELECTRICALLY APPROVED POWER CORD.

THE SOCKET OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE.

Product Identification Marking is located on the bottom of units.

VQT2M46 (E NG)

∫ About the battery pack

CAUTION

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.

• Do not heat or expose to flame.

• Do not leave the battery(ies) in an automobile exposed to direct sunlight for a

long period of time with doors and windows closed.

Warn ing

Risk of fire, explosion and burns. Do not disassemble, heat above 60 xC or incinerate.

∫ About the battery charger

CAUTION!

• DO NOT INSTALL OR PLACE THIS UNIT IN A BOOKCASE, BUILT-IN CABINET OR IN ANOTHER CONFINED SPACE. ENSURE THE UNIT IS WELL VENTILATED. TO PREVENT RISK OF ELECTRIC SHOCK OR FIRE HAZARD DUE TO OVERHEATING, ENSURE THAT CURTAINS AND ANY OTHER MATERIALS DO NOT OBSTRUCT THE VENTILATION VENTS.

• DO NOT OBSTRUCT THE UNIT’S VENTILATION OPENINGS WITH NEWSPAPERS, TABLECLOTHS, CURTAINS, AND SIMILAR ITEMS.

• DO NOT PLACE SOURCES OF NAKED FLAMES, SUCH AS LIGHTED CANDLES, ON THE UNIT.

• DISPOSE OF BATTERIES IN AN ENVIRONMENTALLY FRIENDLY MANNER.

• The battery charger is in the standby condition when the AC power supply cord is connected. The primary circuit is always “live” as long as the power cord is connected to an electrical outlet.

(ENG) VQT2M46

∫ Cautions for Use

• Always use a genuine Panasonic AC adaptor (DMW-AC5G; optional). Always use a genuine Panasonic multi conversion adaptor (DMW-MCA1; optional).

•

• When using an AC adaptor, use the AC cable supplied with the AC adaptor.

• Do not use any other AV cables except the supplied one.

• Do not use any other cables except a genuine Panasonic HDMI mini cable

(RP-CDHM15, RP-CDHM30; optional). Part numbers: RP-CDHM15 (1.5 m), RP-CDHM30 (3.0 m)

• Do not use any other USB connection cables except the supplied one.

In the event of abnormal operation (e.g. if the unit emits smoke or an unusual smell), immediately stop operating the unit and consult the Panasonic Customer Care Centre on 132600.

Keep the camera as far away as possible from electromagnetic equipment (such as microwave ovens, TVs, video games etc.).

• If you use the camera on top of or near a TV, the pictures and sound on the camera may be disrupted by electromagnetic wave radiation.

• Do not use the camera near cell phones because doing so may result in noise adversely affecting the pictures and sound.

• Recorded data may be damaged, or pictures may be distorted, by strong magnetic fields created by speakers or large motors.

• Electromagnetic wave radiation generated by microprocessors may adversely affect the camera, disturbing the pictures and sound.

• If the camera is adversely affected by electromagnetic equipment and stops functioning properly, turn the camera off and remove the battery or disconnect AC adaptor (DMW-AC5G; optional). Then reinsert the battery or reconnect AC adaptor and turn the camera on.

Do not use the camera near radio transmitters or high-voltage lines.

• If you record near radio transmitters or high-voltage lines, the recorded pictures and sound may be adversely affected.

-If you see this symbol-

Information on Disposal in other Countries outside the European Union

This symbol is only valid in the European Union. If you wish to discard this product, please contact your local authorities or dealer and ask for the correct method of disposal.

VQT2M46 (E NG)

Contents

Information for Your Safety...........................................................................2

(Important) About the waterproof/

dustproof and anti-shock performance of the camera................................... 6

Maintenance and waterproof performance ...................................................8

• Using the camera underwater...............................................................12

• Causes of water leak ............................................................................ 13

• Caring of the camera after using it underwater..................................... 14

Standard Accessories ................................................................................. 16

Names of the Components .........................................................................17

Charging the Battery ...................................................................................19

About the Built-in Memory/the Card ............................................................ 21

Inserting and Removing the Card (optional)/the Battery ............................. 22

Setting Date/Time (Clock Set)..................................................................... 23

• Changing the clock setting .................................................................... 23

Setting the Menu.........................................................................................24

Selecting the [REC] Mode........................................................................... 25

Taking pictures using the automatic function (

ñ: Intelligent Auto Mode) .........................................................................26

• Scene detection ....................................................................................27

• AF Tracking Function............................................................................27

Recording Motion Picture............................................................................ 28

Playing back Pictures ([NORMAL PLAY])...................................................29

Deleting Pictures......................................................................................... 29

Reading the Operating Instructions

(PDF format) ...............................................................................................30

Specifications..............................................................................................32

(ENG) VQT2M46

(Important) About the waterproof/ dustproof and anti-shock performance of the camera

• Please observe the following precautions, and avoid using this camera in any

situation where the camera is subject to high water pressure. This camera’s waterproof/dustproof rating complies with the “IPX8” and “IP6X” ratings. Provided the care and maintenance guidelines described in this document are strictly followed, this camera can operate underwater, to a depth not exceeding 10 m for a time not exceeding 60 minutes.

• This camera also complies with “MIL-STD 810F (Method 516.5-Shock)”. The

camera has cleared a drop test from a height of 2 m onto 3 cm thick plywood. In most cases this camera should not sustain any damage if dropped from a height not exceeding 2 m.

• Supplied accessories are not waterproof (excluding hand strap/silicon jacket).

¢1 This means that the camera can be used underwater for specified time in

specified pressure in accordance with the handling method established by Panasonic. This does not guarantee no destruction, no malfunction, or waterproofing in all conditions.

¢2 This does not guarantee no destruction, no malfunction, or waterproofing in all

conditions.

Observe the following precautions and avoid using under water pressure exceeding the guaranteed performance, and in an environment with excessive dust or sand. Waterproofing is not guaranteed if the unit is subject to an impact as a result of being hit or dropped etc. If an impact to the camera occurs, it should be inspected (subject to a fee) by a Panasonic’s service centre to verify that the waterproofing is still effective. Any malfunction caused by customer misuse, or mishandling will not be covered by the warranty.

Note

The picture can become whitish if there is dirt e.g. fingerprints on the lens.

•

When it is dirty, lightly wipe the surface of the lens with soft and dry cloth.

¢2

¢1

VQT2M46 (E NG)

∫ Handling of the camera

•

Do not leave the camera for a long period of time in places where temperature is very low (ski resort etc.) or very high (above 40 oC), inside a car under strong sunlight, close to a heater, on the beach, etc. Waterproof performance may be degraded.

• The inside of this unit is not waterproof. Do not open or close the card/battery

door or terminal cover close to the water by the sea, a lake or river, or with wet hands.

• Waterproof function of the camera is for sea water and fresh water only.

• Operation may not be possible when snow or water on the zoom lever, mode

dial or camera [OFF/ON] button the buttons freezes at cold places like ski

resorts etc.

∫ About the [PRECAUTIONS] demonstration display

Please check beforehand to maintain the waterproof performance.

•

[PRECAUTIONS] is displayed when the power is turned on for the first time after purchase, with the card/battery door completely closed.

The [PRECAUTIONS] screen will not display the next time

•

you turn on the power if you start the slide show by selecting [YES], and then select [END] once it has completed. Select [REPLAY] to see the slide show again.

Note

•

It will automatically skip to clock setting screen if [NO] is selected before the slide show starts.

• [PRECAUTIONS] is displayed every time the power is turned on if you exited the

slide show using a method other than selecting [END], such as turning off the power while the slide show is playing.

• This can be also confirmed from [PRECAUTIONS] in the [SETUP] menu.

(ENG) VQT2M46

Maintenance and waterproof performance

∫ To prevent water leaking into the camera, observe the following

items before using it.

∫ Check that there is enough remaining battery power or memory in

the card.

∫ Do not open or close the card/battery door or terminal cover in

places with sand and dust, near water, or with wet hands.

∫ At purchase, the [LOCK] switch is in the locked state. When opening

the card/battery door and terminal cover, first release the lock.

Release the lock by sliding the [LOCK] switch in the direction of the arrow until

•

the red area becomes visible, and open the card/battery door and terminal cover.

A: [LOCK] switch (grey part) B: Locked state

Red part

C: D: Released state

VQT2M46 (E NG)

Confirm that there are no foreign objects on inner side of the card/battery door or terminal cover (B rubber seal and C place where rubber seal meets).

A: Terminal cover B: Rubber seal C: Area where rubber seal

sits

D: Card/Battery door E: Hair and lint F: Sand and dust G: Crack and deformation H:Fluid

• If there is any crack or deformation in the rubber seal inside the card/battery

door and terminal cover, get the camera inspected or repaired by the dealer or an authorised Panasonic’s service centre.

If there is any foreign object, remove with attached brush.

I: Brush (supplied)

• If there is any foreign object, such as lint, hair, sand, etc., on the

surrounding area, water will leak within a few seconds causing malfunction.

(ENG) VQT2M46

Example of foreign object on the inner side of the card/battery door

J: Area where rubber seal

sits (around the card/ battery compartment)

K: Rubber seal site (around

the card/battery cover)

Example of foreign object on the inner side of the terminal cover

L: Area where rubber seal

sits (around the connection terminal)

M: Rubber seal site (around

the terminal cover)

• Wipe it off with a dry soft cloth if there is any liquid.

• The integrity of the rubber seals may decrease after about 1 year, with use and

age. To avoid permanently damaging the camera the seals should be replaced once each year. Please contact Panasonic’s Service Centre for related costs and other information.

VQT2M46 (E NG)

1:With the [LOCK] switch released, close the card/

battery door and terminal cover by pushing until you hear a click.

• To prevent water seeping into the camera, be careful not to trap foreign

objects such as liquids, sand, hair or dust etc.

• Closing the door with the [LOCK] switch in the locked state may result in

damage or leaks.

2:Slide the [LOCK] switch in the direction of the arrow

until the visible red portion is no longer visible and the switch is locked.

• If you use the camera without securely closing the door and cover, it may

open and close of its own accord.

Red part

N: O: [LOCK] switch (grey part) P: Released state Q: Locked state

Note

If there is any foreign object, remove it

•

with attached brush.

• Sand and dust etc. will unintentionally

adhere to the camera by lodging in between the gap around the card/ battery door or terminal cover when used in the following locations:

– Where sand is floating, such as in the

sea or water etc.

– Where there is a lot of sand or dust,

such as at the beach or in a sand box etc.

• To prevent unintentional opening of the card/battery door and terminal

cover, it is recommended to use the supplied silicon jacket.

(ENG) VQT2M46

+ 25 hidden pages