FAQ’s Guide
L Connect the AC adaptor and telephone line cords and charge the battery for 7 hours
before initial use.
L Please read this FAQ’s Guide before using the unit and save for future reference.
Frequently asked questions
Call waiting (using the recall button)
Question Cause & solution
How do I answer
the 2nd call when I
am talking with
someone?
How can I use the
call waiting service?
How can I make a
conference call?
L Press {RECALL} {2} whilst on call 1, this will switch to 2nd
call, press {RECALL} {2} again to alternate between calls or
return to 1st call, or {RECALL} {1} to terminate current call.
L
Call waiting is a service provided by your service provider/
telephone company. For additional information on the use of
this service contact your service provider/telephone company.
Conference call with an outside call
When the other handset is on an outside call, press {LINE1} or
{LINE2} on the additional handset that is being used by another
handset to join a conversation “CALL SHARE”.
OR
Press {INTERCOM} and the extension number of the other
person that you desire to join the outside call. When the paged
party answers, press {CONF} to activate the conference call.
Conference call with 2 outside calls
1 During an outside call, press {HOLD} 2 times.
2 To answer a 2nd call, press {LINE1} or {LINE2}.
To make a 2nd call, press {LINE1} or {LINE2}, then dial the
phone number.
3 When the 2nd call is connected, press {CONF} to make a
conference call.
L
If you subscribe to the conference call service provided by your
service provider/telephone company, please consult your service
provider/telephone company for full instructions on this feature.
PQQW15408ZA DM0706SY0
Question Cause & solution
Why call waiting
does not work when
I press {RECALL}?
Battery charge
Question Cause & solution
How do I charge the
battery?
Can I leave the
handset on the
base unit or charger
after battery is fully
charged or each
call is finished?
Where can I buy
new battery?
Range/Distance (“No link to base.”)
Question Cause & solution
What is the range/
distance of my
cordless phone?
(Why am I getting
short or poor range/
distance on my
cordless phone?)
Why is “No link
to base.”
displayed on the
handset when I
press {C}?
L You may be required to change the recall time to “90ms”.
(Default: “100ms”)
L Make sure you have subscribed to the call waiting service.
Consult your service provider/telephone company.
L Make sure that the battery is properly installed in the handset
and the cover is closed. Place the handset on the base unit or
charger and confirm “Charging” is displayed.
L It takes approx. 7 hours to charge the empty battery (see front
page). When it is fully charged, “Charge completed” is
displayed.
L You can place the handset on the base unit or charger
anytime. Battery is not overcharged and there is no damage
to the battery. By placing the handset on the base unit or
charger, it is always fully charged.
L Battery can be purchased through your local retailer.
L Range/distance is related to technology and environmental
factors. Therefore we cannot provide a given range or
distance.
L Make sure that the AC adaptor is properly connected to wall
socket and to the base unit and that beep tones sound when
you page the handset from the base unit.
L Move closer to the base unit (Allow up to 60 seconds for the
handset to reassign to the base unit.).
L If you try manual registration process, allow up to 60 seconds
for the handset to reassign to the base unit.
L If the above remedies do not solve the problem, refer to the
troubleshooting section in your Operating Instructions for
more information.
– 2 –