Panasonic agya70p Operation Manual
Before attempting to connect, operate or adjust this product, please read these instructions completely.
AG- P
SDI Interface Board
1 (E)
Installation of the AG-YA70
The AG-YA70 is an interface board that enables the AG-MX70 to be connected to a serial digital interface (SDI).
Follow the procedure below to install it.
<Note>
Always consult your dealer or authorized service centre regarding installation of the AG-YA70 in the AG-MX70.
S
Screws (6 pcs)
Screws
(20 pcs)
Blank panel
2) Remove the six screws from the rear panel, then
remove the blank panel.
3) Open the top unit, including the LCD, from the front,
then release the bands securing the flexible cable and
blue cable of the unit.
4) Remove the power cable connected to the top unit,
then position the top unit upright.
When doing so, ensure the flexible and other cables
do not become detached.
5) Remove the twenty screws from the shield casing,
then remove the casing itself.
1) Turn off the power of the AG-MX70 and remove the
ten screws from the bottom panel.
Screws (10 pcs)
EXT IN
P
P
KEY
Y
R
B
P
YC
R
P
YC
R
L
R
1
VIDEO IN
P /V6
P
Y/V
1
Y/V
3 4
R
YC
B
R
P /V8
P
YC
B
R
AUDIO IN
L
2
2
R
P /V5
Y/V
B
P /V7
Y/V
B
L
MIC
PHONE
VY
VY
L
3
U
P
B
P
B
Loading...