Panasonic agve70p Operation Manual
Before attempting to connect, operate or adjust this product, please read these instructions completely.
AG- P
3D Effect Board
1 (E)
Installation of the AG-VE70
The AG-VE70 is a 3D effect board that enables the 3D patterns, etc. of the AG-MX70 to be used.
Follow the procedure below to install it.
<Note>
Always consult your dealer or authorized service centre regarding installation of the AG-VE70 in the AG-MX70.
Fixing screws for
AG-VE70
1) Turn off the power of the AG-MX70 and remove the
ten screws from the bottom panel.
Screws (10 pcs)
Screws
(20 pcs)
2) Open the unit in the top part including the LCD out
toward the front, then release the bands securing the
flexible cable and blue cable of the unit.
3) Remove the power cable connected to the top unit,
then position the top unit upright.
When doing so, ensure the flexible and other cables
do not become detached.
4) Remove the twenty screws from the shield casing,
then remove the casing itself.
5) Remove the five hexagonal screws for anchoring the
AG-VE70 to the motherboard.
Loading...