Panasonic 9TGWL18A Users Manual

FCC ID :ACJ9TGWL18A

WLAN+BT module adapter

Model number: WL18A

User Manual

GENERAL

This device is the WLAN+BT module adapter IEEE802.11a/b/g/n/ac, dual band 2x2 Wi-Fi
+Bluetooth® adapter.

Integration to the end product

1. WL18A module is mounted in the main board.

2. Insert Antenna unit into Antenna connectors of WL18A module.

Technical Specification

a) Dimensions (H x W x D): 22mm x 30mm x 2.4mm
b) Weight: 2.8g
c) IEEE WLAN Standard: IEEE802.11a/b/g/n/ac
d) Bluetooth: BDR, EDR, Low energy
e) Antenna Diversity: Supported
f) Operating Temperature: -10 to 50 degree Celsius
g) Humidity: 30 to 80 %RH
h) Host interface: USB2.0 and PCIe v2.1 Gen1

FCC ID :ACJ9TGWL18A

Regulatory Information

Federal Communications Commission Radio Frequency Interference
Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may

cause undesired operation.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment.

This equipment may not be collocated or operated with any other antenna or transmitter.

This device meets the government’s requirements for exposure to radio waves.

This device is designed and manufactured not to exceed the emission limits for exposure

to radio frequency (RF) energy set by the Federal Communications Commission of the U.S.

Government.

The exposure standard for wireless device employs a unit of measurement known as the

Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg.

* Tests for SAR are conducted using standard operating positions accepted by the FCC

with the device transmitting at its highest certified power level in all tested frequency bands.

Although the SAR is determined at the highest certified power level, the actual SAR level

of the device while operating can be well below the maximum value. This is because the

device is designed to operate at multiple power levels so as to use only the poser required

to reach the network. In general, the closer you are to a wireless base station antenna, the

lower the power output.