Panasonic 9TB092CRB User Manual

CD-ROM DRIVE UNIT
CR-594-J / CR-594-K
INSTRUCTION MANUAL
Please read through these instructions before operating this unit.
Interface : ATAPI
CD-ROM DRIVE UNIT
INSTRUCTION MANUAL
Please read through these instructions before operating this unit.
Interface : ATAPI
* Model CR-594-J
TABLE OF CONTENTS
IMPORTANT SAFETY NOTICE ................................................................................ iv
LASER SAFETY INFORMATION ............................................................................. A-1
INTRODUCTION........................................................................................................ A-2
1. PRECAUTIONS WHEN OPERATING................................................................... A-3
1.1 PRECAUTIONS WHEN TRANSPORTING...................................................... A-3
1.2 INSTALLATION LOCATION ............................................................................ A-3
1.3 PRECAUTIONS FOR USE .............................................................................. A-3
1.4 PRECAUTIONS FOR OPERATION ................................................................ A-3
1.5 PRECAUTIONS WHEN HANDLING DISCS.................................................... A-3
2. PARTS AND FUNCTIONS .................................................................................... A-5
2.1 FRONT VIEW................................................................................................... A-5
2.2 REAR VIEW ..................................................................................................... A-5
3. CONNECTIONS..................................................................................................... A-6
3.1 CONNECTING VIEW....................................................................................... A-6
4. GUIDE TO OPERATION ....................................................................................... A-6
4.1 INSTALLATIONS ............................................................................................. A-6
5. GENERAL DESCRIPTION .................................................................................... A-7
5.1 FEATURE SUMMARY ..................................................................................... A-7
5.2 SYSTEM SET UP ............................................................................................ A-7
5.3 POWER SAVING ............................................................................................. A-7
6. SPECIFICATION SUMMARY................................................................................ A-7
6.1 PERFORMANCE ............................................................................................. A-7
6.2 ERROR RATES ............................................................................................... A-8
6.3 AUDIO PERFORMANCE................................................................................. A-8
6.4 GENERAL PERFORMANCE ........................................................................... A-9
6.5 ENVIRONMENTAL CONDITIONS................................................................... A-9
6.6 PICK UP LASER .............................................................................................. A-9
7. BEFORE REQUESTING SERVICE....................................................................... A-9
7.1 TROUBLESHOOTING ..................................................................................... A-9
APPENDIX ...............................................................................................................A-10
ENGLISH
iii
IMPORTANT SAFETY NOTICE
NOTICE
(1) You may not reproduce or transcribe any part of this publication without permission. (2) We reserve the right to revise this document at any time without notice. (3) If you have any questions about this document, contact your sales representative.
SAFETY NOTICE
(1) To prevent fire or electric shock, do not expose this appliance to rain or moisture. (2) To avoid electric shock or damage to the eyes due to laser beam, do not attempt to
disassemble the cabinet.
For USA
(Model CR-594-J only)
FEDERAL COMMUNICATIONS COMMISSION (FCC) RADIO FREQUENCY INTERFERENCE STATEMENT
Class B Computing Device
NOTE : This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and , if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures :
- - Reorient or relocate the receiving antenna.
- - Increase the separation between the equipment and receiver.
- - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- - Consult the dealer or an experienced radio/TV technician for help.
FCC WARNING : Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
iv
LASER SAFETY INFORMATION
Class 1 LASER Product
This equipment is certified to comply with DHHS Rule 21 CFR Chapter 1,Subchapter J in effect as of date of manufacture. Elsewhere, the drive is certified to conform to the requirements of the International Electrotechnical Commission (IEC) 825 and CENELEC EN60825 for Class 1 laser products. Class 1 laser products are not considered to be hazardous. To ensure continued product safety, the following precautions should be heeded.
Caution :
(1) The use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
(2) The drive is designed to be incorporated into a computer-based system or unit which
has an enclosing cover. The drive may not be used as a stand-alone unit.
(3) Do not open the drive unit; no user adjustments or serviceable parts are inside.
CLASS 1 LASER PRODUCT LASER KLASSE 1 LUOKAN 1 LASERLAITE KLASS 1 LASER APPARAT APPAREIL A LASER DE CLASSE 1 EN60825
ENGLISH
• This label is attached to the upper shield at the top of the drive unit.
• Dieses Etikett ist auf der oberen Abschirmung oben auf der Laufwerkseinheit angebracht.
• Märkningen återfinns på den översta kåpan överst på drivenheten. (For Swedish)
• Denne merkelappen er festet til det øverste dekselet på toppen av spilleren.(For Norwegian)
• Denne etiket er sat fast på den øverste skærm på drev-enhedens top. (For Danish)
• Tämä etiketti on liimattu voimayksikön yläosan suojalevyyn. (For Finnish)
(For German)
A-1
LASER Specification
Type: Semiconductor laser AlGaAs Wave Length:760 ~ 815 nm (Typical 785 nm) Divergence: Output Power: 0.15 mW
θ
= 53.5 °
LASER Spesifikasjon: (For Norwegian)
Type: Halvleder laser AlGaAs Bølgelengde:760 ~ 815 nm (Typisk 785 nm) Divergens: Utgangseffekt: 0,15 mW
θ
= 53,5 °
Laser-Daten: (For German)
Typ: Halbleiter-Laser AlGaAs Wellenlänge:760 ~ 815 nm (Typical 785 nm) Divergenz: Ausgangsleistung: 0,15 mW
Laser- specifikationer: (For Swedish)
Typ: Laserhalvedare AlGaAs Våglängd: 760 ~ 815 nm (Typiskt 785 nm) Divergens: Uteffekt: 0,15 mW
θ
= 53,5 °
θ
= 53,5 °
Laser Specifikationer: (For Danish)
Type: Semiconductor AlGaAs Bølge-længde:760 ~ 815 nm (Typisk 785 nm) Divergens: Udgang-effekt: 0,15 mW
LASERin tekniset tiedot: (For Finnish)
Tyyppi: Laserpuolijohdin AlGaAs Aallon pituus:760 ~ 815 nm (Tyypillinen 785 nm) Hajaantuminen: Teho: 0,15 mW
θ
= 53,5 °
θ
= 53,5 °
INTRODUCTION
CD-ROM drive is read-only memory using an audio compact disc system as a media package which handles digital data. To enjoy audio CD, please insert the Headphone plug into the Headphone jack. (Model CR-594-J only)
This drive unit uses CD-ROM discs which bear the following mark.
COMPACT
Only compact discs having this mark can be used with this unit.
COMPACT
DIGITAL AUDIO
System Requirements
• Computer IBM PC-AT or Compatible
• Operating System PC-DOS Ver. 5.0 or later MS-DOS Ver. 5.0 or later MS Windows 3.1/NT3.5/NT3.51/NT4.0 MS Windows 95 / 98 OS/2 2.1X or later
A-2
Loading...
+ 9 hidden pages